• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-28 22:55来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 - make sure that there is continuity on the coaxial cable between the MMR1 and the glide antenna 1/2 (4RT) (Ref. ASM 34-36/01)

 - replace the coaxial cable if necessary

 - make sure that there is discontinuity between the core and the shield of the coaxial cable

 - repair if necessary

 - install the MMR1

 - install the glide antenna 1/2 (4RT) (Ref. AMM TASK 34-36-18-400-001).

 

 (2) If the test of the MMR1 does not give the maintenance message GLIDE ANTENNA (4RT)/COAX CABLE/MMR1(40RT1):


 - replace the MMR that you installed on side 2.
 B. If the test of the MMR2 only gives the maintenance message
 GLIDE ANTENNA (4RT)/COAX CABLE/MMR2(40RT2):

 - swap the MMR-1 (40RT1) and the MMR-2 (40RT2) (Ref. AMM TASK 34-36-31-000-002) and (Ref. AMM TASK 34-36-31-400-002)

 - do the BITE test of the MMR2 (Ref. AMM TASK 34-36-00-740-003).


 (1) If the test of the MMR2 gives the maintenance message GLIDE ANTENNA (4RT)/COAX CABLE/MMR2(40RT2):
 - remove the MMR2

 - remove the glide antenna 1/2 (Ref. AMM TASK 34-36-18-000-001)

 - make sure that there is continuity on the coaxial cable between the MMR2 and the glide antenna 1/2 (4RT) (Ref. ASM 34-36/01)

 - replace the coaxial cable if necessary

 - make sure that there is discontinuity between the core and the shield of the coaxial cable

 - repair if necessary

 - install the MMR2

 - install the glide antenna 1/2 (4RT) (Ref. AMM TASK 34-36-18-400-001).


 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞34-36-00∞∞∞∞∞∞∞∞∞∞Page 294
 May 01/05 CES


 (2) If the test of the MMR2 does not give the maintenance message
 GLIDE ANTENNA (4RT)/COAX CABLE/MMR2(40RT2):

 - replace the MMR that you installed on side 1.
 C. If the test of the MMR1 gives the maintenance message GLIDE ANTENNA (4RT)/COAX CABLE/MMR1(40RT1) and if the test of the MMR2 gives the maintenance message GLIDE ANTENNA (4RT)/COAX CABLE/MMR2(40RT2):
 - replace the ANTENNA-GLIDE/SLOPE 1/2 (4RT) (Ref. AMM TASK 34-36-11-000-001) and (Ref. AMM TASK 34-36-11-400-001).
 D. Do the test given in Para. 3.
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞34-36-00∞∞∞∞∞∞∞∞∞∞Page 295
 May 01/05R
 CES


 TASK 34-36-00-810-848
 Loss of the GPS Antenna 1 Signal

 1. Possible Causes
_______________
 - ANTENNA-GPS ACTIVE, 1 (43RT1)
 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R  AMM 20-28-00-912-003 Electrical Bonding of Electrical Connectors AMM 34-36-00-740-003 BITE Test of the MMR AMM 34-36-16-000-001 Removal of the GPS Active Antenna (43RT1, 43RT2) AMM 34-36-16-400-001 Installation of the GPS Active Antenna (43RT1, 43RT2)
 with Teflon Seal AMM 34-36-31-000-002 Removal of the Multi Mode Receiver (40RT1, 40RT2) AMM 34-36-31-400-002 Installation of the Multi Mode Receiver (40RT1,
 40RT2) R SRM 517400 P.Block001
 3. Fault Confirmation
__________________ **ON A/C ALL R Post SB 34-1147 For A/C 001-004,051-060,
 A. Test Do the BITE test of the MMR1 (Ref. AMM TASK 34-36-00-740-003).


 **ON A/C ALL
 4. Fault Isolation_______________
 **ON A/C ALL 
R  Post SB  34-1147 For A/C 001-004,051-060,
R R R R R R  A. If the test gives the maintenance message GPS ANTENNA1(43RT1)/COAX CABLE/MMR1(40RT1): - remove the MMR1 (Ref. AMM TASK 34-36-31-000-002) - remove the GPS antenna 1 (Ref. AMM TASK 34-36-16-000-001) - make sure that there is no moisture and/or corrosion on the coaxial cable of the GPS antenna 1 - if you find corrosion damage, refer to the Structural Repair Manual (Ref. SRM 517400 P.Block001) for types, inspection, removal and corrosion protection. - make sure that there is continuity on the coaxial cable of the GPS antenna 1 (Ref. AMM TASK 20-28-00-912-003) - replace the coaxial cable if necessary - make sure that there is discontinuity between the core and shield of the coaxial cable of the GPS antenna 1 - repair if necessary.
 (1) If the fault stops: - install the MMR1 (Ref. AMM TASK 34-36-31-400-002) - install the GPS antenna 1 (Ref. AMM TASK 34-36-16-400-001).
 (2) If the fault continues: - install a new ANTENNA-GPS ACTIVE, 1 (43RT1) (Ref. AMM TASK 34-36-16-400-001) - install the MMR1 (Ref. AMM TASK 34-36-31-400-002).
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320 Trouble Shooting Manual 排故手册 导航 NAVIGATION 2(129)