• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-27 12:57来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
71-71-42-991-301 Fig. 601
 3. Job Set-up
__________ Subtask 71-71-42-941-051
 A. Safety Precautions
 (1) On the center pedestal, on the ENG panel 115VU:

 (a) Put a warning notice to tell persons not to start the engine.

 (2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.

 (3) On the overhead maintenance panel 50VU:


 (a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
 F 『 EEFF : ALL E Page 60171-71-42
 E E Feb 01/98 E E ECES E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E


 (b) Put a warning notice to tell persons not to energize the FADEC 1(2).
 4. Procedure
_________ Subtask 71-71-42-210-050
 A. Visual inspection of the drain mast outlet.
 (Ref. Fig. 601/TASK 71-71-42-991-301)

 (1) Examine the drain mast outlet for unwanted material which could cause blockage of fluids.
 Subtask 71-71-42-140-050
 B. Remove unwanted material from drain mast outlet and clean outlet as
 required to remove any blockage.

 5. Close-up
________ Subtask 71-71-42-869-053
 A. Make sure that the work area is clean and clear of tool(s) and other items.
 Subtask 71-71-42-942-051
 B. Remove the warning notice(s).
 F 『 EEFF : ALL E Page 60271-71-42
 E E Feb 01/98 E E ECES E F 『 E C F M E E E E 56-5B E

 

 Drain Mast
 Figure 601/TASK 71-71-42-991-301

 F 『 EEFF : ALL E Page 60371-71-42
 E E Feb 01/98 E E ECES E

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E


 DRAIN MANIFOLD MODULE - REMOVAL/INSTALLATION
____________________________________________ TASK 71-71-43-000-041 Removal of the Drain Manifold Module
 1. Reason for the Job

__________________
 Self Explanatory


 2. Job Set-up Information


______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific container No specific protective covers No specific warning notice
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors 71-71-42-000-041 Removal of the Drain Mast 71-71-43-991-300 Fig. 401
 3. Job Set-up
__________ Subtask 71-71-43-941-050
 A. Safety Precautions
 (1) On the center pedestal, on the ENG panel 115VU:

 (a) Put a warning notice to tell persons not to start the engine.

 (2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.


 F 『 EEFF : ALL E Page 40171-71-43
 E E Feb 01/98 E E ECES E

 F  『
 E  C F M  E
 E  E


 E 56-5B E
 E E
 (3) On the overhead maintenance panel 50VU:

 (a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.

 (b) Put a warning notice to tell persons not to energize the FADEC 1(2).


 Subtask 71-71-43-010-051
 B. Open the fan cowl doors: (Ref. TASK 71-13-00-010-040)
 FOR 1000EM1
 437AL, 438AR
 FOR 1000EM2
 447AL, 448AR

 4. Procedure
_________ (Ref. Fig. 401/TASK 71-71-43-991-300) Subtask 71-71-43-020-050
 A. Removal of the Drain Manifold Module
 (1) Remove the drain mast (Ref. TASK 71-71-42-000-041)

 (2) Put the container below the drain manifold module to catch unwanted fluids.

 (3) Disconnect: CAUTION : USE A SECOND WRENCH TO HOLD THE FITTINGS WHEN YOU


_______ LOOSEN/TIGHTEN THE TUBE COUPLING NUTS. THIS PREVENTS DAMAGE TO THE TUBES.
 (a) Disconnect the oil/hydraulic, the fuel, and the reservoir module tubes from the right side of the drain manifold module (20).

 (b) Disconnect the heat exchanger, the fan case, and the oil tank scupper tubes from the left side of the manifold module (20).


 (4) Remove the bolts (5), the washers (10), and the nuts (15) that attach the manifold module (20) to the engine brackets.
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM 动力装置 POWER PLANT 2(104)