R 4_Not Applicable
1EFF : 401-499, 1 32-46-00Page 63 1 1 Config-2 Aug 01/05 1 1 1CES 1R Specific Data - Detail R Figure 020A (SHEET 1)
1EFF : 401-499, 1 32-46-00Page 64 1 1 Config-2 Aug 01/05 1 1 1CES 1R Specific Data - Detail R Figure 020A (SHEET 2)
1EFF : 401-499, 1 32-46-00Page 65 1 1 Config-2 Aug 01/05 1 1 1CES 1R Specific Data - Detail R Figure 020A (SHEET 3)
1EFF : 401-499, 1 32-46-00Page 66 1 1 Config-2 Aug 01/05 1 1 1CES 1
BRAKES AND STEERING - BITE - SERVICING
______________________________________
TASK 32-46-00-610-001
BITE Test of the BSCU - Selection of the Pin Programming
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific warning notice(s)
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power 31-32-00-860-009 Procedure to Get Access to the SYSTEM REPORT/TEST/L/G Page ASM 32-42/02
R **ON A/C 001-049, 051-099, 101-105, 151-199, 201-220, 301-399,
R 32-46-00-991-001-A Fig. 301 **ON A/C 106-149, 221-299,
32-46-00-991-001-B Fig. 301A R
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 32-46-00Page 301 1201-299, 301-399, 1Aug 01/05 1 1 1CES 1R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
3. Job Set-up
__________
Subtask 32-46-00-860-050
A. Aircraft Maintenance Configuration
(1)
On the panel 400VU, make sure that the L/G normal control lever is set to DOWN.
(2)
On the panel 402VU, make sure that the A/SKID & NOSE WHEEL switch is at ON.
(3)
Energize the aircraft electrical circuits
(Ref. TASK 24-41-00-861-002).
(4)
On the MCDU, get the SYSTEM REPORT/TEST L/G page (Ref. TASK 31-32-00-860-009).
Subtask 32-46-00-941-052
B. Safety Precautions
(1) Put a warning notice(s) on the L/G normal control lever to tell persons not to move it.
Subtask 32-46-00-865-052
C. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU HYDRAULIC/BRAKING AND STEERING/SYS2/SPLY 4GG M36 121VU HYDRAULIC/BRAKING AND STEERING/SYS2/CTL 3GG M35 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/CTL 1GG M34 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/IND AND/SPLY 2GG M33
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 32-46-00Page 302 1201-299, 301-399, 1Aug 01/05 1 1 1CES 1
4. Procedure
_________
**ON A/C 001-049, 051-099, 101-105, 151-199, 201-220, 301-399,
Subtask 32-46-00-970-050-A
A. Selection of the BSCU Pin-Programming R R (Ref. Fig. 301/TASK 32-46-00-991-001-A) R
(1) Do a visual check of the brakes and main tires and note the informations (tire size, brake manufacturer) if you could not get these data from a previous BSCU installation (LRU IDENTICATION page).
NOTE : In case of doubt, always refer to the latest certified wheel
____ and brake configuration applicable to the aircraft.
NOTE : The PIN-PROG SELECTION page may be different according to the
____ BSCU standard (some selections may not be found). You will find below some information to understand all the selections.
NOTE : Unless specified on the MCDU page, A320 means A319/A320
____
-MBFG: (MESSIER BUGATTI or GOODRICH for A319/A320-MESSIER/GOODRICH FOR A321)
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM LANDING GEAR 起落架8(14)
