R 4. Procedure_________
R Subtask 10-12-00-620-094
R A. Protection
R (1) Apply SPECIAL MATERIALS (Material No. 05-043) on all the seals of the
R doors.
R (2) Make sure that all the doors operate correctly.
R Subtask 10-12-00-210-079
R B. Inspection
R (1) Make sure that the extension of the landing gear shock absorbers is
R correct.
R (2) Do a check of the pressure of the oxygen cylinders.
R (3) Do a fuel sampling for microbiological contamination (Ref. TASK 12-
R 32-28-281-003) or (Ref. TASK 12-32-28-281-004).
R (4) If you find contamination:
R (a) Do a shock treatment :
R - if premixed fuel with biocide is available (Ref. TASK 28-11-00-
R 600-004) or (Ref. TASK 28-11-00-600-004).
R - If premixed fuel with biocide is not available (Ref. TASK 28-
R 11-00-600-004) or (Ref. TASK 28-11-00-600-004).
R (b) Do a preventive treatment :
R 1_ If premixed fuel is available:
R - refuel the wing tanks to 90% to the total capacity with fuel
R premixed with biocide (Ref. TASK 28-11-00-600-007) or
R (Ref. TASK 28-11-00-600-007).
R - Refuel the center tank to 30% to the total capacity with
R fuel premixed with biocide (Ref. TASK 28-11-00-600-007) or
R (Ref. TASK 28-11-00-600-007).
R 2_ If premixed fuel is not available:
R - Refuel the wing tanks to 90% of the total capacity with fuel
R not premixed with biocide (Ref. TASK 28-11-00-600-007) or
R (Ref. TASK 28-11-00-600-007).
-Refuel the center tank to 30% of the total capacity with no premixed fuel with biocide (Ref. TASK 28-11-00-600-007) or (Ref. TASK 28-11-00-600-007).
(5) Drain water from all the fuel tanks (Ref. TASK 12-32-28-281-001) NOTE : Do the water drain procedure one hour after refueling is
____
completed.
(6) Close all the fuel system valves.
Subtask 10-12-00-710-071
C. Do these Tests:
(1)
Do a test of the avionics equipment ventilation (Ref. TASK 21-26-00-710-001).
(2)
If the aft cargo-compartment ventilation-system is installed, do a test of the aft cargo-compartment ventilation-system (Ref. TASK 21-28-00-710-006).
(3)
If the FWD cargo-compartment ventilation-system is installed, do a test of the FWD cargo-compartment ventilation-system (Ref. TASK 21-28-00-720-003).
(4)
Do a test of the wing ice-protection system (Ref. TASK 30-11-00-710-001).
(5)
Do a test of the engine air intake ice protection (Ref. TASK 30-21-00-710-001).
(6)
Do a test of the ENG 1(2) LP fuel valve 12MQ(13MQ) (Ref. TASK 28-24-00-710-002).
5. Close-up
________ R **ON A/C 001-003, 051-054,
Subtask 10-12-00-410-059-A
A. Put the Aircraft back to its Initial Configuration
(1)
On the overhead panel 25VU, on the CABIN PRESS section:
-Push the DITCHING pushbutton switch to close the avionics ventilation skin valves.
(2)
De-energize the aircraft electrical circuits supplied from the external power (Ref. TASK 24-41-00-862-002).
(3)
Close the passenger/crew doors (Ref. TASK 52-10-00-410-001).
(4)
Close the FWD and AFT cargo-compartement doors (Ref. TASK 52-30-00-860-002).
(5)
Close the bulk cargo-compartment door (Ref. TASK 52-30-00-860-008).
(6)
Close the emergency exit doors (Ref. TASK 52-22-00-410-001).
(7)
Seal with STORAGE PRESERVATION (Material No. 15-002) and adhesive tape:
-
the avionics ventilation system inlets and outlets (15HQ and 22HQ)
-
the outflow valve (10HL)
-
the doors and the handles.
(8)
Remove all the fixtures, tools, test and support equipment used during this procedure.
R **ON A/C 004-049, 055-099, 101-149, 151-199, 201-299, 301-399, 401-499,
Subtask 10-12-00-410-059
A. Put the Aircraft back to its Initial Configuration
(1)
On the overhead panel 25VU, on the CABIN PRESS section:
-Push the DITCHING pushbutton switch to close the avionics ventilation skin valves.
中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址:A320飞机维护手册 AMM PARKING, MOORING, STORAGE & RETURN TO S(42)