曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
frequency, may be assigned.
d. A controller may omit the ground or local
control frequency if the controller believes the pilot
knows which frequency is in use. If the ground
control frequency is in the 121 MHz bandwidth the
controller may omit the numbers preceding the
decimal point; e.g., 121.7, “CONTACT GROUND
POINT SEVEN.” However, if any doubt exists as to
what frequency is in use, the pilot should promptly
request the controller to provide that information.
e. Controllers will normally avoid issuing a radio
frequency change to helicopters, known to be
single‐piloted, which are hovering, air taxiing, or
flying near the ground. At times, it may be necessary
for pilots to alert ATC regarding single pilot
operations to minimize delay of essential ATC
communications. Whenever possible, ATC instructions
will be relayed through the frequency being
monitored until a frequency change can be
accomplished. You must promptly advise ATC if you
are unable to comply with a frequency change. Also,
you should advise ATC if you must land to
accomplish the frequency change unless it is clear the
landing will have no impact on other air traffic;
e.g.,on a taxiway or in a helicopter operating area.
2/14/08 AIM
Airport Operations 4-3-13
4-3-15. Gate Holding Due to Departure
Delays
a. Pilots should contact ground control or
clearance delivery prior to starting engines as gate
hold procedures will be in effect whenever departure
delays exceed or are anticipated to exceed
15minutes. The sequence for departure will be
maintained in accordance with initial call up unless
modified by flow control restrictions. Pilots should
monitor the ground control or clearance delivery
frequency for engine startup advisories or new
proposed start time if the delay changes.
b. The tower controller will consider that pilots of
turbine‐powered aircraft are ready for takeoff when
they reach the runway or warm‐up block unless
advised otherwise.
4-3-16. VFR Flights in Terminal Areas
Use reasonable restraint in exercising the prerogative
of VFR flight, especially in terminal areas. The
weather minimums and distances from clouds are
minimums. Giving yourself a greater margin in
specific instances is just good judgment.
a. Approach Area. Conducting a VFR operation
in a Class B, Class C, Class D, and Class E surface
area when the official visibility is 3 or 4 miles is not
prohibited, but good judgment would dictate that you
keep out of the approach area.
b. Reduced Visibility. It has always been recognized
that precipitation reduces forward visibility.
Consequently, although again it may be perfectly
legal to cancel your IFR flight plan at any time you
can proceed VFR, it is good practice, when
precipitation is occurring, to continue IFR operation
into a terminal area until you are reasonably close to
your destination.
c. Simulated Instrument Flights. In conducting
simulated instrument flights, be sure that the weather
is good enough to compensate for the restricted
visibility of the safety pilot and your greater
concentration on your flight instruments. Give
yourself a little greater margin when your flight plan
lies in or near a busy airway or close to an airport.
4-3-17. VFR Helicopter Operations at
Controlled Airports
a. General.
1. The following ATC procedures and phraseologies
recognize the unique capabilities of helicopters
and were developed to improve service to all users.
Helicopter design characteristics and user needs often
require operations from movement areas and
nonmovement areas within the airport boundary. In
order for ATC to properly apply these procedures, it
is essential that pilots familiarize themselves with the
local operations and make it known to controllers
when additional instructions are necessary.
2. Insofar as possible, helicopter operations will
be instructed to avoid the flow of fixed‐wing aircraft
to minimize overall delays; however, there will be
many situations where faster/larger helicopters may
be integrated with fixed‐wing aircraft for the benefit
of all concerned. Examples would include IFR
flights, avoidance of noise sensitive areas, or use of
runways/taxiways to minimize the hazardous effects
of rotor downwash in congested areas.
3. Because helicopter pilots are intimately
familiar with the effects of rotor downwash, they are
best qualified to determine if a given operation can be
conducted safely. Accordingly, the pilot has the final
authority with respect to the specific airspeed/altitude
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
航空信息手册2008上(122)
