曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
(See MINIMUM DESCENT ALTITUDE.)
HEIGHT ABOVE LANDING- The height above a
designated helicopter landing area used for helicopter
instrument approach procedures.
(Refer to 14 CFR Part 97.)
HEIGHT ABOVE TOUCHDOWN- The height of
the Decision Height or Minimum Descent Altitude
above the highest runway elevation in the touchdown
zone (first 3,000 feet of the runway). HAT is
published on instrument approach charts in conjunction
with all straight‐in minimums.
(See DECISION HEIGHT.)
(See MINIMUM DESCENT ALTITUDE.)
HELICOPTER- Rotorcraft that, for its horizontal
motion, depends principally on its engine‐driven
rotors.
(See ICAO term HELICOPTER.)
HELICOPTER [ICAO]- A heavier‐than‐air aircraft
supported in flight chiefly by the reactions of the air
on one or more power‐driven rotors on substantially
vertical axes.
HELIPAD- A small, designated area, usually with a
prepared surface, on a heliport, airport, landing/takeoff
area, apron/ramp, or movement area used for
takeoff, landing, or parking of helicopters.
HELIPORT- An area of land, water, or structure used
or intended to be used for the landing and takeoff of
helicopters and includes its buildings and facilities if
any.
HELIPORT REFERENCE POINT (HRP)- The
geographic center of a heliport.
HERTZ- The standard radio equivalent of frequency
in cycles per second of an electromagnetic wave.
Kilohertz (kHz) is a frequency of one thousand cycles
per second. Megahertz (MHz) is a frequency of one
million cycles per second.
HF-
(See HIGH FREQUENCY.)
HF COMMUNICATIONS-
(See HIGH FREQUENCY COMMUNICATIONS.)
HIGH ALTITUDE REDESIGN (HAR)- A level of
non-restrictive routing (NRR) service for aircraft
that have all waypoints associated with the HAR
program in their flight management systems or
RNAV equipage.
Pilot/Controller Glossary 2/14/08
PCG H-2
HIGH FREQUENCY- The frequency band between
3 and 30 MHz.
(See HIGH FREQUENCY COMMUNICATIONS.)
HIGH FREQUENCY COMMUNICATIONS- High
radio frequencies (HF) between 3 and 30 MHz used
for air‐to‐ground voice communication in overseas
operations.
HIGH SPEED EXIT-
(See HIGH SPEED TAXIWAY.)
HIGH SPEED TAXIWAY- A long radius taxiway
designed and provided with lighting or marking to
define the path of aircraft, traveling at high speed (up
to 60 knots), from the runway center to a point on the
center of a taxiway. Also referred to as long radius
exit or turn‐off taxiway. The high speed taxiway is
designed to expedite aircraft turning off the runway
after landing, thus reducing runway occupancy time.
HIGH SPEED TURNOFF-
(See HIGH SPEED TAXIWAY.)
HIWAS-
(See HAZARDOUS INFLIGHT WEATHER
ADVISORY SERVICE.)
HIWAS AREA-
(See HAZARDOUS INFLIGHT WEATHER
ADVISORY SERVICE.)
HIWAS BROADCAST AREA- A geographical area
of responsibility including one or more HIWAS
outlet areas assigned to an AFSS/FSS for hazardous
weather advisory broadcasting.
HIWAS OUTLET AREA- An area defined as a 150
NM radius of a HIWAS outlet, expanded as necessary
to provide coverage.
HOLD FOR RELEASE- Used by ATC to delay an
aircraft for traffic management reasons; i.e., weather,
traffic volume, etc. Hold for release instructions
(including departure delay information) are used to
inform a pilot or a controller (either directly or
through an authorized relay) that an IFR departure
clearance is not valid until a release time or additional
instructions have been received.
(See ICAO term HOLDING POINT.)
HOLD IN LIEU OF PROCEDURE TURN- A hold
in lieu of procedure turn shall be established over a
final or intermediate fix when an approach can be
made from a properly aligned holding pattern. The
hold in lieu of procedure turn permits the pilot to
align with the final or intermediate segment of the
approach and/or descend in the holding pattern to an
altitude that will permit a normal descent to the final
approach fix altitude. The hold in lieu of procedure
turn is a required maneuver (the same as a procedure
turn) unless the aircraft is being radar vectored to the
final approach course, when “NoPT” is shown on the
approach chart, or when the pilot requests or the
controller advises the pilot to make a “straight-in”
approach.
HOLD PROCEDURE- A predetermined maneuver
which keeps aircraft within a specified airspace while
awaiting further clearance from air traffic control.
Also used during ground operations to keep aircraft
within a specified area or at a specified point while
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
Air Traffic Control空中交通管制2(119)
