-------------------------------------------------------------------------------
20-28-00-912-004 Electrical Bonding of Components With Conductive Bolts and Screws and Bonding Straps in the Fuselage and in the Wings (this does not include the tanks)-
27-50-00-866-009 Retraction of the Flaps on the Ground 27-54-00-710-001 Operational Test of the Flap System 27-54-41-400-001 Installation of the Right Angle Gearbox
6203CM,(6253CM) 27-54-62-400-002 Installation of the Outboard Double-Slotted Flap 57-55-11-000-005 Removal of the Inboard and Outboard Flap Tab
Hinge-Fairings
1EFF : 301-399, 1 27-54-62Page 499 1 1 May 01/05R 1 1 1CES 1
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
57-55-11-010-002 To Lower the Flap Track No. 3 & No. 4 Movable Fairings for Access 57-55-11-400-005 Installation of the Inboard and Outboard Flap Tab Hinge-Fairings 57-55-11-410-002 To Lift the Flap Track No. 3 & No. 4 Movable Fairings
after Access 27-54-62-991-036 Fig. 424 27-54-62-991-037 Fig. 425 27-54-62-991-035 Fig. 426
3. Job Set-up
__________
Subtask 27-54-62-941-063
A. Safety Precautions
(1)
Make sure that the safety barriers are in position.
(2)
Make sure that the warning notice is in position on panel 400VU to tell persons not to operate the landing gear.
(3)
Make sure that the warning notice is in position to tell persons not to operate the flight controls.
Subtask 27-54-62-865-065
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
Subtask 27-54-62-860-064
C. Aircraft Maintenance Configuration
WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
1EFF : 301-399, 1 27-54-62Page A400 1 1 May 01/05R 1 1 1CES 1
(1)
Make sure that the access platform is below the applicable flap.
(2)
Make sure that the flaps are in the fully retracted position (Ref. TASK 27-50-00-866-009).
(3)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER (98D27803000000) is on the flap/slat control lever.
(4)
Make sure that the fairings have been removed from the tab hinges at the 3A, 3B and 3C positions (Ref. TASK 57-55-11-000-005).
(5)
Make sure that the flap track No. 3 and No. 4 movable fairings have been lowered (Ref. TASK 57-55-11-010-002).
4. Procedure
_________
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
EDGE:
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
Subtask 27-54-62-420-090
A. Preparation for Installation
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL
_______ MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
(1)
Clean the component interface and/or the adjacent area with a MISCELLANEOUS (Material No. 19-003) made moist with CLEANING AGENTS (Material No. 11-004).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵6(83)
