(6)
Set the seals and the clamping strips equally between the inboard flap and the outboard flap.
(7)
TORQUE the screws (1) and (19) to between 0.4 and 0.45 m.daN (35.39 and 39.82 lbf.in).
(8)
Remove the ADJUSTER-KINK SEAL (UPPER FWD WY5396) and the ADJUSTER-KINK SEAL (UPPER AFT WY5658) from the flap seals.
**ON A/C 301-399,
Subtask 27-54-61-420-070-B
C. Installation of the Upper Kink-Seals (Ref. Fig. 409A/TASK 27-54-61-991-003-A, 410A/TASK 27-54-61-991-002-A)
(1) Install the upper kink-seal (21), the retainer (20) and the screws
(19) on the inboard flap. Do not tighten the screws (19).
R 1EFF : ALL 1 27-54-61Page 466 1 1 Aug 01/05 1 1 1CES 1
Kink Upper-Seal Installation Tool.
Figure 411/TASK 27-54-61-991-011
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 27-54-61Page 467 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
(2)
Install the upper kink-seal (3), the pressure plate (2) and the screws (1) on the outboard flap. Do not tighten the screws (1).
(3)
Set the seals and the clamping strips equally between the inboard flap and the outboard flap.
(4)
TORQUE the screws (1) and (19) to between 0.4 and 0.45 m.daN (35.39 and 39.82 lbf.in).
**ON A/C ALL
Subtask 27-54-61-420-071-A
D. Installation of the Lower Kink-Seals R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
(Ref. Fig. 409/TASK 27-54-61-991-003)
**ON A/C 301-399,
(Ref. Fig. 409A/TASK 27-54-61-991-003-A) R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
(Ref. Fig. 410/TASK 27-54-61-991-002)
**ON A/C 301-399,
(Ref. Fig. 410A/TASK 27-54-61-991-002-A)
**ON A/C ALL
(1) Attach the lower kink-seal (7) to the inboard and outboard flap with the screws (8).
5. Close-up
________ Subtask 27-54-61-860-051
A. Aircraft Configuration
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the LOCKING TOOL - FLAP/SLAT CONTROL LEVER from the slat/flap control lever.
(3) Fully retract the flaps (Ref. TASK 27-50-00-866-009). Subtask 27-54-61-942-058
B. Removal of Equipment
(1)
Remove the safety barriers.
(2)
Remove the warning notice(s).
(3)
Remove the access platform(s).
(4)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
1EFF : ALL 1 27-54-61Page 469 1 1 Aug 01/05R 1 1 1CES 1
TASK 27-54-61-000-005
Removal of the Inboard Flap Seals
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s) No specific safety barriers No specific warning notice No specific access platform 3.0 m (9 ft. 10 in.) 98D27803000000 1 LOCKING TOOL - FLAP/SLAT CONTROL LEVER
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-50-00-866-008 Extension of the Flaps on the Ground 27-54-61-991-050 Fig. 412
1EFF : ALL 1 27-54-61Page 470 1 1 Aug 01/05R 1 1 1CES 1
3. Job Set-up
__________ Subtask 27-54-61-941-065
A. Safety Precautions
(1)
Put the safety barriers in position.
(2)
Put a warning notice on the panel 400VU to tell persons not to operate the landing gear.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵6(33)
