A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵3(191)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

R Subtask 27-50-00-941-063
R A. Safety Precautions Energize the Aircraft Electrical Circuits from the External Power De-energize the Aircraft Electrical Circuits Supplied from the External Power Installation of the Flap/Slat Control-Lever Locking Tool (98D27803000000) Pressurize the Yellow Hydraulic System Pressurize the Blue Hydraulic System with a Ground Power Supply Depressurize the Yellow Hydraulic System Depressurize the Blue Hydraulic System Disconnection of the Isolation Coupling of the Power Transfer Unit (PTU) Connection of the Isolation Coupling of the Power Transfer Unit (PTU) EIS Start Procedure EIS Stop Procedure
R (1) Put the safety barriers in position.
R (2) Put the warning notice(s) in position to tell persons that the flap R and slat systems are in operation. R Subtask 27-50-00-860-065 R B. Aircraft Maintenance Configuration R WARNING : OBEY THE HYDRAULIC SAFETY PROCEDURES.
_______
R (1) Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-R 002).

 (2) If applicable, disconnect the Power Transfer Unit (PTU) (Ref. TASK 29-23-00-860-001).
 NOTE : The flaps move at full-speed if the Power Transfer Unit (PTU)____ is in operation. If the PTU is disconnected (electrically or hydraulically), only the yellow flap motor operates and the flaps move at half-speed.
 NOTE : An ECAM F/CTL FLAP SYS 1 FAULT message will show when the PTU____ is isolated. This message can be ignored.
 (3) Pressurize the Yellow hydraulic system (Ref. TASK 29-10-00-863-002).
 (4) Pressurize the Blue hydraulic system (Ref. TASK 29-10-00-863-003).
 NOTE : The Blue and/or Green hydraulic system(s) operate(s) the slat____ system. If necessary, use the alternative hydraulic system.
 Subtask 27-50-00-865-069
 C. Make sure that this(these) circuit breaker(s) is(are) closed:
 -------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 49VU FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1 121VU FLIGHT CONTROLS/WTB/FLP/SYS2 121VU FLIGHT CONTROLS/WTB/SLT/SYS2 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 121VU FLIGHT CONTROLS/SLT/CTL/SYS2 122VU FLIGHT CONTROLS/WTB/FLP/SYS1 122VU FLIGHT CONTROLS/WTB/SLT/SYS1  6CV 5CV 12CV 11CV 8CV 7CV 10CV 9CV  B07B06P20P19Q21R21S07S06 
R  Subtask 27-50-00-865-071 
R  D. Open, safety and tag this(these) circuit breaker(s): 
R R R R R  -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU AUTO FLT/FAC1/26VAC 14CC1 B03 121VU AUTO FLT/FAC2/26VAC 14CC2 M18

 

 4. Procedure
_________ Subtask 27-50-00-866-061
 A. Extension of the Flaps/Slats on the Ground WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
 (1)
 Do the EIS start procedure (Ref. TASK 31-60-00-860-001).

 (2)
 Set the flap/slat control lever to the applicable position 1, 2, 3 or FULL.

 (3)
 Make sure that on the ECAM upper DU:

 -
the flap position bar moves to the set position

 -
the slat position bar moves to the set position.

 

 (4)
 Install the LOCKING TOOL - FLAP/SLAT CONTROL LEVER (98D27803000000) on the flap/slat control lever (Ref. TASK 27-00-00-480-002).

 5. Close-up
________ Subtask 27-50-00-860-066
 A. Aircraft Maintenance Configuration
 (1)
 Depressurize the Yellow hydraulic system (Ref. TASK 29-10-00-864-002).

 (2)
 Depressurize the Blue hydraulic system (Ref. TASK 29-10-00-864-003).

 (3)
 If applicable, connect the PTU (Ref. TASK 29-23-00-860-002).

 (4)
 Do the EIS stop procedure (Ref. TASK 31-60-00-860-002).

 (5)
 De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).

 1EFF : ALL 1 27-50-00Page 208 1 1 May 01/04R 1 1 1CES 1

 Subtask 27-50-00-942-063
 B. Removal of Equipment
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Remove the safety barriers.

 (3)
 Remove the warning notice(s).

 (4)
 Remove the ground support and maintenance equipment, the special and standard tools and all other items.

 1EFF : ALL 1 27-50-00Page 209 1 1 May 01/04R 1 1 1CES 1

 TASK 27-50-00-866-011
 Manual Extension of the Flaps
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵3(191)