TB 20 MAINTENANCE MANUAL 05 TIME LIMITS MAINTENANCE CHECKS TB20飞机维护手册 05 时间限制维护检查 2(67)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

61-10 36) Visually inspect the propeller and the bulkhead(s) for impact marks and evidence of corrosion. Make sure that the strip is present on the bulkhead(s) (if installed). 100 NOTE 1 
61-10 37) Check the propeller tightening torque - refer to 100  
 20-00-01 201.   
30-60 38) Check the fluid level of the propeller de-icing system (if installed) - refer to 30-60-00 201. 100 NOTE 1 
30-60 39) Visually inspect the propeller de-icing system
components (if installed) : tank, flange - refer to 100 NOTE 1 
 30-60-00 201.   
30-60 40) Visually inspect the supply lines of the propeller de-icing system (if installed) for routing, and condition of attach fittings - refer to 30-60-00 201. 000 NOTE 1 
61-10 41) Install propeller spinner 111, make sure that washers are installed under the screw heads - refer to 61-10-00 401. 100 NOTE 1 

NOTE 1 : If a 100-hr. inspection has been carried out during the last 3 months, do not perform this operation unless this annual inspection replaces a 100-hr. inspection. For US registered aircraft, perform all operations.
 

ATA ANNUAL INSPECTION (Al)
ENGINE COMPARTMENT INSPECTION (AREA 100) AREA OTHER
INSPECTION PERFORMED
BY
61-10 42) Visually inspect the propeller governor. 100 NOTE 1 
37-00 43) Replace the vacuum system filter (SIGMATEK pump, if installed). 100 500 hrs 
37-00 44) Replace the (mechanical) AIRBORNE vacuum pump drive (if installed). 100 Recommen  ded 6 years  
74-10 45) Perform an overhaul of the TCM magneto. 100 Associated
with engine
overhaul or 
   4 years 
74-10 46) Check the TCM magneto, the attach fittings and the grounding. Refer to the latest issue of LYCOMING 100 100 hrs or
1 year 
 Service Bulletin No. 515 (SB 643 Teledyne Continental, Paragraphs 1 and 2B).   
74-10 47) Check the TCM magneto, the attach fittings and the grounding. Refer to the latest issue of LYCOMING 100 500 hrs 
 Service Bulletin No. 515 (SB 643 Teledyne Continental, Paragraphs 2A and 3).   
74-10 48) Check breaker points for pitting and minimum gap. 100 NOTE 1 
74-10 49) Check for excessive oil in the breaker compartment ; if found, wipe dry with a clean lint-free cloth. 100 NOTE 1 
74-10 50) The felt located at the breaker points should be lubricated in accordance with the magneto manufacturer's
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：TB 20 MAINTENANCE MANUAL 05 TIME LIMITS MAINTENANCE CHECKS TB20飞机维护手册 05 时间限制维护检查 2(67)