曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
28-40 18) Remove the L.H. tank capacitor gages (if installed). 500
Check the sensors for condition, check the transmitter for
corrosion or deposits, check the connections for security.
Replace the 0-ring seal.
Install the capacitor gages - refer to 28-40-01 401.
30-10 19) Visually inspect the porous leading edges (if installed) on the L.H. wing. 500
33-40 20) Visually inspect the navigation lights on the L.H. wing, the lamps and (if installed) the anti-collision and identification lights. Check the domes, glasses, supports and attach fittings for condition. 500
Check the setting of the lights - refer to 33-40-01 201.
57-10 21) Visually inspect all the wing splices, check for cracks and evidence of corrosion on the splices ; make sure the nuts have not rotated, in case of doubt, torque the nuts - refer to 20-00-01 201. 000
57-00 22) Visually inspect the wing structure for corrosion - refer to 57-00-00 201. 000 2000 hrs or
5 years
NOTE : For salty or highly humid operating
atmospheres, the inspection shall be
performed every 2000 hours or 3 years. NOTE
57-00 23) Thoroughly examine the spar flanges/skin junction from root to N4 rib for corrosion - refer to 57-00-00 201.
NOTE : If PR is applied between (upper and lower surface) skin and spar for repair, do the inspection at 10000 hrs or 10 years. 000
4 years 4000 hrs or
8 years,
then 2000 hrs or
NOTE
57-10 24) Check the pins of the L.H. wing-to-fuselage front, main and rear attachments ; make sure the nuts have not rotated, in case of doubt, torque the nuts - refer
to 20-00-01 201. 500
57-20 25) Visually inspect the L.H. main-landing-gear attachment area for loose rivets, distortion, cracks and evidence of corrosion. 500
AIAA
Validity : S / N 1 - 9999 05-20-05 (JA) Page 219
JUN 01
ATA "80A" MAJOR INSPECTION
L.H. WING INSPECTION AREA 500) AREA OTHER
INSPECTION PERFORMED
BY
57-20 26) Visually inspect the L.H. main-landing-gear hinged strut attachment bearing and the retraction actuator
attachment fitting. 500
57-20 27) Thoroughly inspect the L.H. main-landing-gear hinged strut attachment bearing - refer to the latest issue of SOCATA SB 10-080-57. 500 6000 Idg. or
4000 hrs,
then
1500 Idg. or
1000 hrs
57-20 28) Visually inspect the L.H. spar for loose rivets, cracks, distortion and evidence of corrosion. 500
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：TB 20 MAINTENANCE MANUAL 05 TIME LIMITS MAINTENANCE CHECKS TB20飞机维护手册 05 时间限制维护检查 2(35)
