「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 101-105, 151-199, 201-228, ∞∞34-11-00∞∞∞∞∞∞∞∞∞∞Page A253
301-399, 401-499, Aug 01/05 CES
(2) If the angle of attack sensor 1 (3FP1) is not damaged:
- no other action is necessary.
(a) After the subsequent flight, if the fault continues:
- replace the SENSOR-ANGLE OF ATTACK, 1 (3FP1).
**ON A/C 001-049, 101-105, 151-199, 201-228,
Post SB 34-1240 For A/C 001-049,101-105,151-199,201-228,
A. If the LOG-BOOK gives the maintenance message AOA SENSOR1 (3FP1)/ADIRU1 (1FP1):
- do a visual check of the angle of attack sensor 1 (3FP1).
(1) If the angle of attack sensor 1 (3FP1) is damaged:
- replace the SENSOR-ANGLE OF ATTACK, 1 (3FP1) (Ref. AMM TASK 34-11-19-000-001) and (Ref. AMM TASK 34-11-19-400-001).
(2) If the angle of attack sensor 1 (3FP1) is not damaged:
- no other action is necessary.
(a) After the subsequent flight, if the fault continues:
- replace the SENSOR-ANGLE OF ATTACK, 1 (3FP1).
B. If the maintenance message AOA SENSOR1 (3FP1)/ADIRU1 (1FP1) is shown in the Ground Scanning, after the test of the angle of attack warning:
- no maintenance action is necessary.
NOTE : At the end of the test, on the ADIRS CDU, set the OFF/NAV/ATT
____ selector switch related to the ADIRU1 to OFF for some seconds then to NAV to cancel the messages (fast re-alignment is not sufficient)
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 101-105, 151-199, 201-228, ∞∞34-11-00∞∞∞∞∞∞∞∞∞∞Page A254
301-399, 401-499, Aug 01/05 CES
R **ON A/C 001-049, 101-105, 151-199, 201-228, 301-399, 401-499,
TASK 34-11-00-810-893
Deterioration of the Angle of Attack Sensor 2
1. Possible Causes_______________
- SENSOR-ANGLE OF ATTACK, 2 (3FP2)
2. Job Set-up Information______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM AMM 34-11-19-000-001 34-11-19-400-001 Removal of the Angle of Attack Sensor (3FP1, 3FP2, 3FP3)Installation of the Angle of Attack Sensor (3FP1, 3FP2, 3FP3)
3. Fault Confirmation__________________
R **ON A/C 001-049, 101-105, 151-199, 201-228, 301-399, 401-499,
Post SB 34-1240 For A/C 211-228,
A. Test Not applicable, you cannot confirm this fault on the ground.
R **ON A/C 001-049, 101-105, 151-199, 201-228, 301-399, 401-499,
4. Fault Isolation_______________
R **ON A/C 001-049, 101-105, 151-199, 201-210, 301-399, 401-499,
A. If the LOG-BOOK gives the maintenance message AOA SNSR2 (3FP2)/ADIRU2 (1FP2): - do a visual check of the angle of attack sensor 2 (3FP2).
(1) If the angle of attack sensor 2 (3FP2) is damaged: - replace the SENSOR-ANGLE OF ATTACK, 2 (3FP2) (Ref. AMM TASK 34-11-19-000-001) and (Ref. AMM TASK 34-11-19-400-001).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 101-105, 151-199, 201-228, ∞∞34-11-00∞∞∞∞∞∞∞∞∞∞Page A255
301-399, 401-499, Aug 01/05 CES
(2) If the angle of attack sensor 2 (3FP2) is not damaged:
- no other action is neccesary.
(a) After the subsequent flight, if the fault continues:
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320 Trouble Shooting Manual 排故手册 导航 NAVIGATION 1(56)
