(2)
On the panel 400VU:
-make sure that the landing gear control-lever 6GA is in the DOWN position
-put warning notice(s) in position to tell persons not to operate the landing gear.
1EFF : ALL 1 32-22-00Page 503 1 1 Aug 01/05 1 1 1CES 1
(3)
On the panel 110VU:
-make sure that the free fall control handle is folded into the center console
-put warning notice(s) in position to tell persons not to operate the free fall control handle.
(4)
Open the NLG doors and the MLG doors (Ref. TASK 32-22-00-010-001) (Ref. TASK 32-12-00-010-001).
(5)
Make sure that a GROUND LOCK SLEEVE is installed on each MLG door (Ref. TASK 32-00-00-481-002).
(6)
Obey the flight configuration precautions (Ref. TASK 32-00-00-860-001).
(7)
Lift the aircraft at the forward jacking point (Ref. TASK 07-11-00-581-003).
(8)
Put a access platform in position below the zone 123.
Subtask 32-22-00-865-051
B. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU L/G/LGCIU/SYS1/NORM 1GA C09 121VU HYDRAULIC/LGCIU/SYS2 2GA Q35 121VU HYDRAULIC/LGCIU/SYS1/GRND SPLY 52GA Q34
4. Procedure
_________
(Ref. Fig. 501/TASK 32-22-00-991-006, 502/TASK 32-22-00-991-005)
R **ON A/C 001-049, 051-061, 101-105, 201-203,
(Ref. Fig. 503/TASK 32-22-00-991-007)
R **ON A/C 062-099, 151-199, 204-212,
(Ref. Fig. 503A/TASK 32-22-00-991-007-A)
1EFF : ALL 1 32-22-00Page 504 1 1 May 01/05 1 1 1CES 1
NLG - Aft Door Adjustment Figure 501/TASK 32-22-00-991-006
1EFF : 1 1R 1CES ALL 1 11 1 32-22-00 Page 505 Nov 01/01
NLG - Leg Fairing Adjustment Figure 502/TASK 32-22-00-991-005
1EFF : 1 1R 1CES ALL 1 11 1 32-22-00 Page 506 Nov 01/01
INTENTIONALLY BLANK
R 1 1
32-22-00Page 507
1 1 Nov 01/01 1 1 1CES 1
NLG - Doors Gaps Figure 503/TASK 32-22-00-991-007- 12 (SHEET 1)
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 32-22-00Page 508 1 1 May 01/05 1 1 1CES 1
NLG - Doors Gaps Figure 503/TASK 32-22-00-991-007- 22 (SHEET 2)
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 32-22-00Page 509 1 1 May 01/05 1 1 1CES 1
NLG - Doors Gaps
Figure 503A/TASK 32-22-00-991-007-A12 (SHEET 1)
R 1EFF : 062-099, 151-199, 204-212, 1 32-22-00Page 510 1 1 May 01/05 1 1 1CES 1
NLG - Doors Gaps
Figure 503A/TASK 32-22-00-991-007-A22 (SHEET 2)
R 1EFF : 062-099, 151-199, 204-212, 1 32-22-00Page 511 1 1 May 01/05 1 1 1CES 1R **ON A/C 106-149, 213-299, 301-399, 401-499,
(Ref. Fig. 503B/TASK 32-22-00-991-007-B)
**ON A/C ALL
Subtask 32-22-00-020-050
A. Disconnect the Rotating Rod of the Aft NLG Door
(Ref. Fig. 501/TASK 32-22-00-991-006)
NOTE : If you do the adjustment of the NLG doors after
____ removal/installation of the aft NLG door do not disconnect the rotating rod from the replaced aft door.
NOTE : You must disconnect the rotating rod to replace the lock-washer
____ (3) before adjustment of the rod (5).
(1)
Remove the cotter pin (6) and discard it, remove the nut (7) and the washer (8).
(2)
Remove the bolt (9) and disconnect the rotating rod from the aft door of the nose landing gear.
(3)
Disengage the tabs of the lockwasher (3) from the nut (2).
(4)
Loosen the nut (2).
(5)
Remove the rod assy (5) from the universal joint (1) and discard the lockwasher (3).
(6)
Install the rod assy (5) with the nut (2) and a new lockwasher (3) on the universal joint (1).
(7)
In order to help the adjustment of the rod turn the nut (4) to get approximately a dimension N = 209 mm (8.2283 in.)
Subtask 32-22-00-020-051
B. Remove the Rod of the Main Door Assy (Ref. TASK 32-31-41-000-001)
1EFF : ALL 1 32-22-00Page 512 1 1 Aug 01/05 1 1 1CES 1 Subtask 32-22-00-867-054
C. Retract the NLG WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE LANDING GEAR ARE CLEAR.
_______
(1)
Remove the access platform(s).
(2)
Pressurize the Green hydraulic system (Ref. TASK 29-10-00-863-001).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM LANDING GEAR 起落架3(138)
