(2)
Remove the safety barriers.
(3)
Remove the warning notice(s).
1EFF : 001-049, 051-061, 101-105, 201-203, 1 12-13-27Page 335 1 1 Aug 01/05R 1 1 1CES 1
(4) Remove the ground support and maintenance equipment, the special and
standard tools and all other items.
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 12-13-27Page 336 1 1 Aug 01/05 1 1 1CES 1R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
TASK 12-13-27-612-005
Drain, Refill and Flush the Flap Actuator Assemblies With Semi-fluid
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
GEAR.
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
1. Reason for the Job
__________________
Refer to the MPD TASK: 275449-06
NOTE : This procedure is done in two steps:
____
-
step one fills the actuator with clean semi-fluid
-
step two removes unwanted semi-fluid from the actuator.
R 1EFF : 062-099, 106-149, 151-199, 204-299, 1 12-13-27Page 337 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s) No specific safety barriers No specific warning notice No specific Torque Wrench : range 0.00 to 1.20 m.daN
(0.00 to 9.00 lbf.ft) A663160 1 FILLING KIT-ACTUATOR FOR FIN 6205CM, 6255CM No specific access platform 2.5 m (8 ft. 2 in.) 460005835 1 GROUND LOCK SLEEVE FOR FIN 6211CM, 6261CM No specific access platform 2.5 m (8 ft. 2 in.) FOR FIN 6221CM, 6271CM, 6233CM, 6283CM No specific access platform 3.0 m (9 ft. 10 in.)
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 04-025
LUBRICANT, SEMIFLUID (Ref. 20-31-00) Material No. 05-115 USA MIL-P-8116B
JOINTING COMPOUND (CONDUCTIVE) (Ref. 20-31-00) Material No. 11-026 GB DEF-STAN 68-148/1
SOLVENT GENERAL PURPOSE (Ref. 20-31-00) Material No. 19-003 USA AMS 3819
LINT-FREE COTTON CLOTH (Ref. 20-31-00)
R 1EFF : 062-099, 106-149, 151-199, 204-299, 1 12-13-27Page 338 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-00-00-080-002 Removal of the Flap/Slat Control-Lever Locking Tool
(98D27803000000) 27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground 27-50-00-866-011 Manual Extension of the Flaps 27-50-00-866-012 Manual Retraction of the Flaps 27-60-00-866-002 Extension-Retraction of the Spoilers for Maintenance
R **ON A/C 062-099, 106-149, 151-199, 204-299, 401-499,
12-13-27-991-005 Fig. 305
**ON A/C 301-399,
12-13-27-991-005-A Fig. 305A
R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
12-13-27-991-006 Fig. 306
FOR FIN 6205CM, 6255CM
32-12-00-010-001 Open the Main Gear Doors for Access
32-12-00-410-001 Close the Main Gear Doors after Access
3. Job Set-up
__________
Subtask 12-13-27-941-056
A. Safety Precautions
(1)
Put a warning notice in position in the cockpit to tell persons not to operate the flight controls.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM SERVICING 1(76)
