• 热门标签

当前位置: 主页 > 航空资料 > 国外资料 >

时间:2010-05-28 01:19来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

should be exercised by the pilot using the same degree
of concern as in collision avoidance.
b. Wake turbulence may be encountered by
aircraft in flight as well as when operating on the
airport movement area.
REFERENCEPilot/
Controller Glossary Term- Wake Turbulence.
c. Pilots are reminded that in operations conducted
behind all aircraft, acceptance of instructions from
ATC in the following situations is an acknowledgment
that the pilot will ensure safe takeoff and
landing intervals and accepts the responsibility for
providing wake turbulence separation.
1. Traffic information.
2. Instructions to follow an aircraft; and
3. The acceptance of a visual approach
clearance.
d. For operations conducted behind heavy aircraft,
ATC will specify the word “heavy” when this
information is known. Pilots of heavy aircraft should
always use the word “heavy” in radio communications.
e. Heavy and large jet aircraft operators should use
the following procedures during an approach to
landing. These procedures establish a dependable
baseline from which pilots of in-trail, lighter aircraft
may reasonably expect to make effective flight path
adjustments to avoid serious wake vortex turbulence.
1. Pilots of aircraft that produce strong wake
vortices should make every attempt to fly on the
established glidepath, not above it; or, if glidepath
guidance is not available, to fly as closely as possible
to a “3-1” glidepath, not above it.
EXAMPLEFly
3,000 feet at 10 miles from touchdown, 1,500 feet at 5
miles, 1,200 feet at 4 miles, and so on to touchdown.
2/14/08 AIM
Wake Turbulence 7-3-7
2. Pilots of aircraft that produce strong wake
vortices should fly as closely as possible to the
approach course centerline or to the extended
centerline of the runway of intended landing as
appropriate to conditions.
f. Pilots operating lighter aircraft on visual
approaches in-trail to aircraft producing strong wake
vortices should use the following procedures to assist
in avoiding wake turbulence. These procedures apply
only to those aircraft that are on visual approaches.
1. Pilots of lighter aircraft should fly on or
abovethe glidepath. Glidepath reference may be
furnished by an ILS, by a visual approach slope
system, by other ground-based approach slope
guidance systems, or by other means. In the absence
of visible glidepath guidance, pilots may very nearly
duplicate a 3-degree glideslope by adhering to the
“3to 1” glidepath principle.
EXAMPLEFly
3,000 feet at 10 miles from touchdown, 1,500 feet at
5miles, 1,200 feet at 4 miles, and so on to touchdown.
2. If the pilot of the lighter following aircraft has
visual contact with the preceding heavier aircraft and
also with the runway, the pilot may further adjust for
possible wake vortex turbulence by the following
practices:
(a) Pick a point of landing no less than
1,000feet from the arrival end of the runway.
(b) Establish a line-of-sight to that landing
point that is above and in front of the heavier
preceding aircraft.
(c) When possible, note the point of landing
of the heavier preceding aircraft and adjust point of
intended landing as necessary.
EXAMPLEA
puff of smoke may appear at the 1,000-foot markings of
the runway, showing that touchdown was that point;
therefore, adjust point of intended landing to the
1,500-foot markings.
(d) Maintain the line-of-sight to the point of
intended landing above and ahead of the heavier
preceding aircraft; maintain it to touchdown.
(e) Land beyond the point of landing of the
preceding heavier aircraft.
3. During visual approaches pilots may ask ATC
for updates on separation and groundspeed with
respect to heavier preceding aircraft, especially when
there is any question of safe separation from wake
turbulence.
7-3-9. Air Traffic Wake Turbulence
Separations
a. Because of the possible effects of wake
turbulence, controllers are required to apply no less
than specified minimum separation for aircraft
operating behind a heavy jet and, in certain instances,
behind large nonheavy aircraft (i.e., B757 aircraft).
1. Separation is applied to aircraft operating
directly behind a heavy/B757 jet at the same altitude
or less than 1,000 feet below:
(a) Heavy jet behind heavy jet-4 miles.
(b) Large/heavy behind B757 - 4 miles.
(c) Small behind B757 - 5 miles.
(d) Small/large aircraft behind heavy jet -
5miles.
2. Also, separation, measured at the time the
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:航空信息手册2008下(118)