曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
Radar vectors lead from the arrival
to either a north or south final
approach course.
The STAR helps controllers manage
the flow of traffic into a busy terminal
area during periods of delays due to
weather. The hold at RADDY Intersection often serves this purpose.
STARs include the name
of the procedure title.
If the en route portion of your flight
ends at the Kimberly VOR, you
should add the Kimberly Transition
to the end of the route description
of your flight plan.
The STAR does not depict terrain
information. You must look at World
Aeronautical Charts (WACs) or
sectional charts to get a feel for the
underlying topography.
Figure 4-15. STAR Interpretation.
VERTICAL NAVIGATION
PLANNING
Included within certain STARs
is information on vertical
navigation planning. This
information is provided to
reduce the amount of low
altitude flying time for high
performance airplanes, like
jets and turboprops. An
expected altitude is given for
a key fix along the route. By
knowing an intermediate altitude in advance when flying a
high performance airplane,
you can plan the power or
thrust settings and airplane
configurations that result in
the most efficient descent in
terms of time and fuel
requirements. Pilots of high
performance airplanes use the
vertical navigation planning
information from the RAMMS
FIVE ARRIVAL at Denver,
Colorado, to plan their descents. [Figure 4-18]
Figure 4-16. Reducing Pilot/Controller Workload.
All altitudes on the chart are
MSL, and distances are in
nautical miles. The MEA for this
route segment is 6,000 feet MSL,
and its length is 35 nautical miles.
From the Albany VOR the transition
follows the 194° radial to the ATHOS
Intersection. From ATHOS, the transition
follows the 354° radial to the Pawling
VOR, where it joins the STAR.
Frequency data is given in
a corner of the chart. Note
that ATIS frequencies for all
airports served are shown.
Each transition is named for its
point of origin. All transitions
come together at Pawling VOR,
the beginning of the actual STAR.
If the enroute portion of your flight ends
at Rockdale VOR, you enter this
transition on your IFR flight plan as
RKA.PWL2. Notice that, as opposed to a
DP, the transition name is stated first,
then the arrival name.
Arrival charts are most often not to
scale, due to the distribution of
important fixes along the route.
You need not fly into JFK to use
this STAR. Republic Airport in
Farmingdale is also served.
Figure 4-17. STAR Symbology.
4-18
4-19
ARRIVAL PROCEDURES
You may accept a STAR within a clearance or you may
file for one in your flight plan. As you near your destination airport, ATC may add a STAR procedure to your
original clearance. Keep in mind that ATC can assign a
STAR even if you have not requested one. If you accept
the clearance, you must have at least a textual description of the procedure in your possession. If you do not
want to use a STAR, you must specify “No STAR” in
the remarks section of your flight plan. You may also
refuse the STAR when it is given to you verbally by
ATC, but the system works better if you advise ATC
ahead of time.
PREPARING FOR THE ARRIVAL
As mentioned before, STARs include navigation fixes
that are used to provide transition and arrival routes from
the en route structure to the final approach course.
They also may lead to a fix where radar vectors will be
provided to intercept the final approach course. You
may have noticed that minimum crossing altitudes and
airspeed restrictions appear on some STARs. These
expected altitudes and airspeeds are not part of your
clearance until ATC includes them verbally. A STAR
is simply a published routing; it does not have the
force of a clearance until issued specifically by ATC.
For example, MEAs printed on STARs are not valid
unless stated within an ATC clearance or in cases of
lost communication. After receiving your arrival clearance, you should review the assigned STAR procedure.
Obtain the airport and weather information as early as
practical. It is recommended that you have this information prior to flying the STAR. If you are landing at an
airport with approach control services that has two or
more published instrument approach procedures, you
will receive advance notice of which instrument
approaches to expect. This information is broadcast
either by ATIS or by a controller. It may not be provided when the visibility is 3 statute miles (SM) or
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
Instrument Procedures Handbook (IPH)仪表程序手册下(95)
