曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
procedures for en route segments are a function of
safety and practicality in flight procedures. These flight
procedures are dependent upon the pilot, the aircraft,
and the navigation system being used, resulting in a
total VOR system accuracy factor, along with an associated probability factor. The pilot/aircraft information
component of these criteria includes pilot ability to
track the radial and the flight track resulting from turns
at various speeds and altitudes under different wind
conditions. The navigation system information
includes navigation facility radial alignment displacement, transmitter monitor tolerance, and receiver
accuracy. All of these factors were considered during
development of en route criteria. From this analysis,
the computations resulted in a total system accuracy
of ±4.5° 95 percent of the time and ±6.7° 99 percent
of the time. The 4.5° figure became the basis for primary area obstacle clearance criteria, airway and
route widths, and the ATC separation procedures. The
6.7° value provides secondary obstacle clearance area
dimensions. Figure 3-7 depicts the primary and secondary obstacle clearance areas.
PRIMARY AREA
The primary obstacle clearance area has a protected
width of 8 nautical miles (NM) with 4 NM on each
side of the centerline. The primary area has widths of
route protection based upon system accuracy of a
±4.5° angle from the NAVAID. These 4.5° lines
extend out from the NAVAID and intersect the boundaries of the primary area at a point approximately 51
NM from the NAVAID. Ideally, the 51 NM point is
where pilots would change over from navigating away
from the facility, to navigating toward the next facility, although this ideal is rarely achieved.
If the distance from the NAVAID to the changeover
point (COP) is more than 51 NM, the outer boundary
of the primary area extends beyond the 4 NM width
along the 4.5° line when the COP is at midpoint. This
Figure 3-6. VHF Jet Routes.
3-7
means the primary area, along with its obstacle clearance criteria, is extended out into what would have
been the secondary area. Additional differences in the
obstacle clearance area result in the case of the effect of
an offset COP or dogleg segment. For protected en
route areas the minimum obstacle clearance in the primary area, not designated as mountainous under Part
95 — IFR altitude is 1,000 feet over the highest obstacle. [Figure 3-8]
Mountainous areas for the Eastern and Western U.S.
are designated in Part 95, as shown in Figure 3-9 on
page 3-8. Additional mountainous areas are designated for Alaska, Hawaii, and Puerto Rico. With some
exceptions, the protected en route area minimum
obstacle clearance over terrain and manmade obstacles in mountainous areas is 2,000 feet. Obstacle
clearance is sometimes reduced to not less than 1,500
feet above terrain in the designated mountainous areas
of the Eastern U.S., Puerto Rico, and Hawaii, and may
be reduced to not less than 1,700 feet in mountainous
areas of the Western U.S. and Alaska. Consideration is
given to the following points before any altitudes providing less than 2,000 feet of terrain clearance are
authorized:
• Areas characterized by precipitous terrain.
• Weather phenomena peculiar to the area.
• Phenomena conducive to marked pressure differentials.
• Type of and distance between navigational facilities.
• Availability of weather services throughout the
area.
• Availability and reliability of altimeter resetting
points along airways and routes in the area.
Altitudes providing at least 1,000 feet of obstacle clearance over towers and/or other manmade obstacles may
be authorized within designated mountainous areas if
the obstacles are not located on precipitous terrain where
Bernoulli Effect is known or suspected to exist.
4.5°
4.5°
51
51
4.5°
4.5°
4 NM
4 NM
4 NM
4 NM
2 NM
2 NM
6.7°
6.7°
6.7°
6.7°
51
51
Primary Obstacle Clearance Area
Secondary Obstacle Clearance Area
Figure 3-7. VHF En Route Obstacle Clearance Areas.
1,000 Feet Above
Highest Obstacle
Primary En Route
Obstacle Clearance Area
Nonmountainous Area
Figure 3-8. Obstacle Clearance - Primary Area.
3-8
Bernoulli Effect, atmospheric eddies, vortices, waves,
and other phenomena that occur in conjunction with disturbed airflow associated with the passage of strong
winds over mountains can result in pressure deficiencies
manifested as very steep horizontal pressure gradients.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
Instrument Procedures Handbook (IPH)仪表程序手册下(61)
