11.
A M.A. Subpart F approved maintenance organisation which employs only one person to both plan and carry out all maintenance can only hold a limited scope of approval rating. The maximum permissible limits are:-
Rev 0, dated 2nd March, 2010 It should be noted that such an organisation may be further limited by DGCA in the scope of approval dependent upon the capability of the particular organisation.
CLASS AIRCRAFT RATING A2 AEROPLANES PISTON ENGINED 5700 KG AND BELOW
CLASS AIRCRAFT RATING A3 SINGLE ENGINED HELICOPTERS PISTON ENGINED 3175 KG ANDBELOW
CLASS AIRCRAFT RATING A4 AIRCRAFT OTHER THAN A1, A2 AND A3 NO LIMITATION
CLASS ENGINES RATING B2 PISTON LESS THAN 450 HP
CLASS COMPONENTS RATING OTHER THAN COMPLETE ENGINES OR APUs C1 TO C20 AS PER CAPABILITY LIST
CLASS SPECIALISED D1 NDT NDT METHOD(S) TO BE SPECIFIED
Rev 0, dated 2nd March, 2010
Table 1
CLASS RATING LIMITATION
AIRCRAFT A2 Aeroplanes 5700 kg and below Will state aeroplane manufacturer or group or series or type and/or the maintenance tasks
A3 Single engined Heli-copters Will state helicopter manufacturer or group or series or type and/or the maintenance task(s)
A4 Aircraft other than A1, A2 and A3 Will state aircraft series or type and/or the maintenance task(s)
ENGINES B1 Turbine Will state engine series or type and/or the maintenance task(s)
B2 Piston Will state engine manufacturer or group or series or type and/or the maintenance task(s)
B3 APU Will state engine manufacturer or series or type and/or the maintenance task(s)
COMPONENTS OTHER THAN COMPLETE ENGINES OR APUs C1 Air Cond & Press Will state aircraft type or aircraft manufacturer or component manufacturer or the particular component and/or cross refer to a capability list in the exposition and/or the maintenance task(s)
C2 Auto Flight
C3 Comms and Nav
C4 Doors — Hatches
C5 Electrical Power
C6 Equipment
C7 Engine — APU
C8 Flight Controls
C9 Fuel — Airframe
C10 Helicopter — Rotors
C11 Helicopter — Trans
C12 Hydraulic
C13 Instruments
C14 Landing Gear
C15 Oxygen
C16 Propellers
C17 Pneumatic
C18 Protection ice/rain/ Fire
C19 Windows
C20 Structural
SPECIALISED SERVICES D1 Non-Destructive Testing Will state particular NDT method(s)
Rev 0, dated 2nd March, 2010
Section 2 CAR M Appendix V Approval Certificate CAR-M Section A Subpart F Maintenance Organisation
Page 1 of 2
Directorate General of Civil Aviation
India
APPROVAL CERTIFICATE
REFERENCE
Pursuant to DGCA Regulations for the time being in force and subject to the conditions specified below, DGCA hereby certifies
[COMPANY NAME] MAINTENANCE ORGANISATION
as a maintenance organization as referred to in CAR-M Section A Subpart F approved to maintain the products listed in the attached approval schedule and issue related certificates to service using the above reference
CONDITIONS:
1.
This approval is limited to that specified in the scope of approval section of the approved maintenance organisation manual, and
2.
This approval requires compliance with the procedures specified in the approved maintenance organisation manual, and
3.
This approval is valid whilst the approved maintenance organization remains in compliance with CAR-M
4.
Subject to compliance with the foregoing conditions, this approval shall remain valid unless the approval has previously been
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：CONTINUING AIRWORTHINESS REQUIREMENTS CAR -M(36)
