R **ON A/C 106-149, 214-299, 301-399, 401-499,
Subtask 23-71-00-710-050-A
A. Test of the CVR
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the overhead control and indicating panel 21VU :
-Push the RCDR/GND CTL
pushbutton switch.
On ACP:
-Set INT/RAD selector switch to INT stable position
-Activate INT pushbutton in reception mode with the volume at its maximum.
-Push and hold the RCDR/CVR TEST pushbutton switch.
On the panel 21VU:
-On the pushbutton switch, the ONlegend comes on.
-the reception pushbutton switch movesfully out.
At the CAPT and F/O stations:
-
Check that a continuous tone isaudible into the Loudspeakers for approximately two seconds.
-
Check that FSK signal (a beep every 4 seconds) is heard on the loudspeakers.
1EFF : ALL 1 23-71-00Page 504 1 1 Aug 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
- After a few seconds (do not - Check that you can hear your words on
release the RCVR/CVR TEST the Loudspeakers.
pushbutton), speak into the If no audio is heard (audio muted),
Handmike Microphone. CVR is fault and not operational.
- Release the RCDR/CVR TEST
pushbutton.
- Release the RCDR/GND CTL - On the pushbutton switch, the ON
pushbutton switch. legend goes off.
- Place the INT/RAD selector
switch on ACP to the center
position.
**ON A/C ALL
Subtask 23-71-00-710-055
B. Test of the CVR channel recording
NOTE : This procedure is correct for the CAPT station. It is the same for
____ the F/O and 3rd Occupant stations. Refer to the data between parentheses.
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the overhead control and On the panel 21VU:
indicating panel 21VU:
- Push the RCDR/GND CTL - On the pushbutton switch, the ON
pushbutton switch. legend comes on.
Make sure that you can hear the
conversations from the CVR microphone
in the 600 ohms headset.
2. On the CAPT (F/O, 3rd Occupant) On the CAPT (F/O, 3rd Occupant) ACP:
ACP :
- Set INT/RAD selector switch to
INT stable position.
1EFF : ALL 1 23-71-00Page 505 1 1 May 01/05R 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
-Activate INT pushbutton in - The reception pushbutton switch moves reception mode with the volume fully out. at its middle position.
3. Put covers on the CVR microphone:
-Speak in the CAPT (F/O, 3rd Make sure that you can hear the
Occupant) microphone. reception in the headset.
4. On the overhead control and indicating panel 21VU:
-Release the RCDR/GND CTL
pushbutton switch.
5. Close-up
________
Subtask 23-71-00-860-050
A. Put the aircraft back to its initial configuration.
(1)
Disconnect the headset and microphones from the CAPT, F/O and 3rd Occupant stations.
(2)
On the ACPs, push the INT transmission and reception pushbutton switches.
(3)
De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
1EFF : ALL 1 23-71-00Page 506 1 1 May 01/05R 1 1 1CES 1
TASK 23-71-00-710-002 Operational Test of the CVR Recording Logic Including Time Delay Relay R NOTE : This procedure is applicable on the CVR and the SSCVR.
____
1. Reason for the Job
__________________
Refer to the MPD TASK: 237100-02
To do a check of the FLT/GND power supply of the CVR.
To do a check of the CVR power supply through the engines.
To make sure that the CVR PWR CUT OFF RELAY 10RK operates correctly.
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM Communications 通讯3(22)
