曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
Deviations (Heading, Altitude, Speed)
In the frame „Deviations‟ you can set the allowable deviations from assigned heading, speed, and altitude. In the picture, the screen shows the default values. For instance, regarding altitude, this means that when you are assigned 16,000 feet, you will not be busted if you fly between 15,700 and 16,300 feet. You can apply the same principle to heading (where the deviation is measured in degrees from your filed route of flight) and speed (in knots per hour).
Other
The right side of the screen, labeled „Other‟, allows you to enter the number of souls on board. You will only ever hear this number played back if you report an emergency. Then you will be requested the type of emergency, the hours of fuel left on board, and the souls on board. You enter which squawk-code is standard for the part of the world you are flying in when visual flight rules apply. You give some input on the altitude below which the speed restriction of 250 knots applies.
Pause at Distance
If you check the box „Pause at Distance‟, you enter the number of nautical miles away from your destination where RC will pause the flight. Typically, you set it to some point just before you start your descent. If you know beforehand that you will have the co-pilot fly the plane, you can set it at 60, which would be the point at which you start preparing for the approach phase. This option allows you to plan a long flight, get your plane to cruising altitude, and go to sleep. When you wake up in the next morning, FS will be paused and the plane ready for you to take the controls.
Display Text
For the hearing impaired, choose „Display Text‟ and all messages from the controllers will be displayed in text.
Chkpt Ding
Choose „Chkpt Ding‟ to hear a bell when you pass a waypoint.
Play Pilot Wavs
Choose „Play Pilot Wavs‟ to hear your answers to the controller instructions. If you would rather speak the replies, and do not want to hear the RC pilot, uncheck this box.
Radar Contact Radar Contact User Interface
Version 4 December 2, 2007
Copyright JDT LLC 2005 Page 113
Interact with AI
By choosing this option, RC will interact with AI aircraft in the vicinity. This will also enable the “AI Chatter” option. When this option is chosen, proper sequencing on the ground at the departure will occur, and you are more likely to see AI being diverted from possible conflict situations while enroute and/or AI speed adjustment as appropriate during final approach. IMPORTANT NOTE – AI still have a mind of their own! The AI Engine is a controller (a bad one) unto itself. You will continue to see unrealistic, even absurd AI behavior if you fly often. Example: Unrealistic separation minima, even piggy-back AI on final. Example: AI flying near airports at what appears to be m3.0 speeds, etc. RC’s “AI Interaction” means just that, that RC will interact with AI to the maximum extent possible given often unrealistic conditions.
Pilot Auto Reply
Choosing „Pilot Autoreply‟ means that any instruction from the controller will be replied to automatically. If you do not check this box, you have to manually acknowledge every instruction.
Tune on Contact
Choosing „Tune on Contact‟ means that RC will set the appropriate frequencies for you. If you do not check this box, you have to set the frequencies manually.
Radar Contact Radar Contact User Interface
Version 4 December 2, 2007
Copyright JDT LLC 2005 Page 114
Keyboard
If you press „Keyboard‟, the following screen is displayed: You can customize the key combinations for RC as much as you want. Use whatever keys you want. Just be careful they do not interfere with the settings of FS itself. For instance, it would not be wise if you set „G‟ to be the key for repeating last instruction, since you would lower the gear at the same time. One thing to note: new key combinations do not take effect until you restart FS. Click Cancel to exit this window without saving. You will return to the Options screen, and if you click OK there, you will be returned to the main screen. Click Save and your settings will be applied in the next session of FS, and to remind you to restart Flight Simulator, the following message will appear:
Radar Contact Radar Contact User Interface
Version 4 December 2, 2007
Copyright JDT LLC 2005 Page 115
Voices
New in version 4, is a convenient way of selecting pilot, co-pilot, and controller voices. By clicking the “Voices” button, the following screen will appear: There is one tab for each type of voice. You can click each button, and hear a sample of that person‟s voice. When you select a voice, or press their button, the national flag of that voice will be displayed on the right. Choose the pilot you want, by selecting the radio button on the pilots‟ tab. The co-pilot can be chosen by clicking the radio button on the co-pilots‟ tab. You choose the controllers for your flight, on the Controllers‟ tab. You can choose as many or as few controllers as you want. Obviously, the more controllers you have selected, the more variety you will have during your flight. For the Pilots‟ Co-Pilots‟ and Controllers‟ tabs, there is a slider under each voice. As you move the slider to the right, the delay between words and phrases will become more obvious. There is a Master Slider on each tab, which moves all sliders at once. You adjust each voice individually, and click the button to hear how your slider setting sounds. The Pilot‟s and Co-Pilot‟s sliders will move together. In other words, if you select John Dekker as Pilot, and set the slider to position 2, the corresponding Co-Pilot slider will be set to 2.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
Radar Contact(41)
