1. SLIDE OR SLIDE-RAFT PACK
B
1. SLIDE OR
SLIDE-RAFT
PACK LOWER SHELF HARNESS LATCH
RELEASE STRAP
A GUIDE RING
LATCH CHAIN
GIRT
LOWER RELEASE STRAP SHELF GIRT
HARNESS LATCH
B A
3. GIRT BAR 3. GIRT BAR
NO. 1, 2, OR 4 PASSENGER DOOR
(COVER NOT SHOWN) INBD A-A
LATCH ASSEMBLY
SEE B
HARNESS LATCH
LATCH CHAIN 3
LATCH CHAIN 1
2
RELEASE RELEASE
STRAP/LATCH RELEASE STRAP/LATCH
CHAIN FASTENER STRAP CHAIN FASTENER GIRT RELEASE STRAP GUIDE RING RELEASE STRAP
SEE A
B-B
1
DOORS 1L, 1R, 2L, AND 2R
2
DOORS 4L AND 4R
3
LENGTH MUST BE 4 CHAIN LINKS
Release Strap Figure 403 (Sheet 1)
A15357
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-66-01
ALL ú ú 05 Page 406 ú May 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL
RELEASE STRAP GIRT BAR
Release Strap
Figure 403 (Sheet 2)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-66-01
ALL ú ú 03 Page 407 ú Mar 20/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A15366
A
757
MAINTENANCE MANUAL
5 LATCH 4 CLEVIS LATCH
DIAMETER ROD 0.25 INCH (6.35 mm)
NOTE:____ PLUS OR MINUS 5 DEGREES. MUST RELEASE AT 20 DEGREES THE LATCH ASSEMBLY 20` |5` 20` |5`
B LATCH ASSEMBLY
4
MAKE SURE THAT THE CLEVIS CAN ROTATE FREELY IN THE LATCH BLOCK ASSEMBLY.
5 YOU MUST USE LESS THAN TEN POUNDS OF FORCE TO RELEASE THE LATCH.
Release Strap Figure 403 (Sheet 3)
L97904
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-66-01
ALL ú ú 02 Page 408 ú May 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
E. Prepare for Removal
S 494-001
WARNING: MAKE SURE YOU INSTALL THE SAFETY PIN SET ON THE CORRECT
_______ EMERGENCY POWER RESERVOIR. ACCIDENTAL OPERATION OF THE EMERGENCY POWER RESERVOIR CAN CAUSE INJURY OR DAMAGE.
(1) Install the safety pin set on the correct emergency power reservoir.
NOTE: The reservoirs for the No. 1 passenger doors are left of
____ the airplane center line above the ceiling between the doors. The reservoir for the right No. 1 door is left of the reservoir for the left No. 1 door. The reservoirs for the No. 2 and 4 passenger doors are above each door.
S 864-002
(2)
Close and latch the door.
S 824-003
(3)
Move the mode selector lever to the DETACH position.
S 014-006
(4)
Remove the cover (2) as follows (Fig. 401):
(a)
Release the center latch to free the latch strap.
(b)
Pull the bottom of the cover (2) inboard to let the latch strap slide through the slots in the center latch.
(c)
Pull the upper latch handles to release the upper latches.
(d)
Pull the cover (2) inboard until the latch strap clears the center latch.
(e)
Remove the cover (2).
S 494-007
(5) Install the safety pin into the inflation cylinder valve on the slide pack.
NOTE: The safety pin is kept in a pouch on the slide pack.
____
S 824-103
(6) If you cannot fully install the safety pin in the lock pin housing on the valve assembly, do these steps:
(a) Install an allen wrench in the center of the pulley housing.
NOTE: You can use an allen wrench with a long handle for
____
easier access.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú 中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：757 AMM 飞机维护手册 EQUIPMENT/FURNISHINGS 2(77)
