F 『R EEFF : 001-049, 051-099, 101-149, 151-152, E Page 41371-00-00
E E154-199, 201-299, 301-399, 401-499, Aug 01/05 E E ECES E
F 『
E C F M E
E E
E 56-5B E
E E
(f) Remove the clamp (10) from the harness for connector 4101KSB and remove the harness from the HCU.
NOTE : Loosely install the screw (15) and nut (20) on the clamp
____ (25) and tighten with your hand.
(g) Disconnect the electrical connectors 401VCA, 402VCA, 403VCA, 404VCA, 405VCA, 406VCA, 407VCA, 408VCA, 409VCA, 447VCA, and 448VCA from the forward pylon junction box. (Ref. Fig. 404/TASK 71-00-00-991-913)
(h) Remove the coupling (5) and disconnect the upper starter duct from the pylon duct. (Ref. Fig. 404/TASK 71-00-00-991-913)
(i) Install protective covers on the open ends of the ducts.
(j) Install blanking plugs on the electrical connectors.
(4) Remove these components from the left side of engine:
(a) Disconnect the thrust reverser harness connector 4100KSA and 4100KSB from the electrical junction box.
(b) Disconnect the suction hose (60) from the coupling half, the pressure hose (55), and the upper case drain hose (50) from the fluid disconnect panel. (Ref. Fig. 405/TASK 71-00-00-991-914)
(c) Disconnect hose/tube (175) from the PRV interface.
(Ref. Fig. 405/TASK 71-00-00-991-914)
(d) Remove the bolts (35), the washers (40) that attach the fuel/return by-pass hose (45), from the fluid disconnect panel. Remove and discard the gasket (10). (Ref. Fig. 405/TASK 71-00-00-991-914)
(e) Remove the bolts (25), the washers (30) that attach the main fuel supply hose (20) to the fluid disconnect panel. Remove and discard the gasket (15). (Ref. Fig. 405/TASK 71-00-00-991-914)
(f) Install the protective covers on the disconnected hoses and tubes.
F 『R EEFF : 001-049, 051-099, 101-149, 151-152, E Page 41471-00-00
E E154-199, 201-299, 301-399, 401-499, Aug 01/05 E E ECES E F 『 E C F M E E E E 56-5B E F 『 E C F M E E E E 56-5B E
R Power Plant - Right Side
R Figure 404A/TASK 71-00-00-991-913-A
F R EEFF : 153-153, 『 E 71-00-00 Page 415
E E May 01/01
E E
ECES E
R Power Plant - Left Side Figure 405/TASK 71-00-00-991-914
F EEFF : E E ECES ALL 『E 71-00-00EEE Page 416 Aug 01/02
F 『
E C F M E
E E
E 56-5B E
E E
(g) Disconnection of the tubes:
CAUTION : USE 2 WRENCHES TO REMOVE OR INSTALL THE TUBE COUPLING
_______ NUTS. ONE WRENCH TO HOLD THE UNION AND ONE TO LOOSEN OR TIGHTEN THE COUPLING NUT. THIS WILL PREVENT DAMAGE TO THE HARDWARE.
1 Disconnect the sense tubes (75) and (80) from the pylon
_
interface tubes.
**ON A/C 001-049, 051-099, 101-149, 201-299, 301-399,
(Ref. Fig. 406/TASK 71-00-00-991-915)
R **ON A/C 151-152, 154-199, 401-499,
(Ref. Fig. 406A/TASK 71-00-00-991-915-A)
R **ON A/C 001-049, 051-099, 101-149, 151-152, 154-199, 201-299, 301-399, R 401-499,
2 Disconnect the pressure tube (70) from the union installed in
_ the upper high-pressure manifold duct (engine 1 only).
**ON A/C 001-049, 051-099, 101-149, 201-299, 301-399,
(Ref. Fig. 406/TASK 71-00-00-991-915)
R **ON A/C 151-152, 154-199, 401-499,
(Ref. Fig. 406A/TASK 71-00-00-991-915-A)
R **ON A/C 001-049, 051-099, 101-149, 151-152, 154-199, 201-299, 301-399, R 401-499,
3 Remove the coupling (65) and disconnect the pylon interface
_
duct from the pylon duct.
**ON A/C 001-049, 051-099, 101-149, 201-299, 301-399,
(Ref. Fig. 406/TASK 71-00-00-991-915)
F 『R EEFF : 001-049, 051-099, 101-149, 151-152, E Page 41771-00-00
E E154-199, 201-299, 301-399, 401-499, Aug 01/05 E E ECES E F 『 E C F M E E E
E 56-5B E
Pneumatic System
Figure 406/TASK 71-00-00-991-915
F 『R EEFF : 001-049, 051-099, 101-149, 201-299, E Page 41871-00-00
E E301-399, May 01/05 E E ECES E F 『 E C F M E E E E 56-5B E
Pneumatic System
Figure 406A/TASK 71-00-00-991-915-A
F 『R EEFF : 151-199, 401-499, E Page 41971-00-00
E E Aug 01/05 E E ECES ER **ON A/C 151-152, 154-199, 401-499,
F 『
E C F M E
E E
E 56-5B E
E E
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM 动力装置 POWER PLANT 1(18)
