(a) 
Remove the access panel in the winglet lower surface.
WARNING: DO NOT TOUCH THE LIGHT WITH YOUR BARE HANDS WHEN THE LIGHT IS HOT. INJURY CAN OCCUR IF YOU TOUCH THE LIGHT BEFORE IT BECOMES COOL.
(b) 
Disconnect the electrical connector from the back of the light.
(c) 
Remove the forward navigation light lens by removing 14 screws [1].
(d) 
Remove the LED Module by removing 4 screws [5].
(e) 
Install a new LED Module and secure with 4 screws [5].
(f)  
Reinstall the forward position light lens and secure with 14 screws [1]. Torque the fasteners to 10-18 in-lbs
NOTE: Recommended to reapply MS122DF release agent to faying surfaces of lens retainer at each removal
(g) 
Reconnect the electrical connector to the back of the light.
(h) 
Reinstall the winglet access panel. 
S 712-003
(3) 
Do a test of the new LED Module.
(a) 
Supply electrical power (AMM 24-22-00/201).
(b) 
Close each circuit breaker that was opened and remove each DO-NOT-OPERATE or DO-NOT-CLOSE tag.
(c) 
At the P5 panel, set the switch to the on position.   Make sure the lights come on correctly.
(d) 
Set the switch to the off position.  Make sure the lights go off.
(e) 
Remove electrical power if it is not necessary (AMM 24-22-00/201).
Aviation Partners Boeing 757-200 MAINTENANCE MANUAL SUPPLEMENT  Part II
Figure 201 
Halogen Light Assembly 
(Forward Navigation Light)
Aviation Partners Boeing 757-200 MAINTENANCE MANUAL SUPPLEMENT  Part II 
[2] Fastener, 2 locations on each retainer 
[3] Reflector 
Assembly, 2 Locations 
[4] Lamp, 2 Locations 
Figure 202 
Halogen Lamp Replacement 
(Forward Navigation Light)
Aviation Partners Boeing 757-200 MAINTENANCE MANUAL SUPPLEMENT  Part II 
Bolt for  
Lens assembly  
(14ea.)  
Adapter plug  
UP  
LED Module  Winglet  
AFT  
Bolt for LED  
Module (4)  
FWD  
Lanyard  Access panel  
Lens assembly  
Figure 203  
LED Module Assembly  
(Forward Navigation Light) 
Aviation Partners Boeing 
757-200 MAINTENANCE MANUAL SUPPLEMENT  Part II 
Aft Position Lights 
Maintenance Practices
1.  General 
A.  This procedure has these tasks: 
(1)  Aft Position Light - Lamp Replacement 
(2) Aft Position Light - Light Assembly Replacement 
TASK 33-43-02-962-001
2.  Aft Position Light - Lamp Replacement (Fig. 201) 
A.  References 
(1)  
AMM TASK 24-22-00-962-028 p201, Remove and Supply Electrical Power
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:757-200 MAINTENANCE MANUAL SUPPLEMENT Part II 维护手册补充(25)