Figure 2-34 WING TANK FUEL WEIGHT
WING TANK (LEFT HAND OR RIGHT HAND SIDE) FUEL WEIGHT PER SIDE (LEFT HAND OR RIGHT HAND) LB (KG) CG -BODY BUTTOCK LINE (BBL) LEVEL AIRPLANE INCH (CM)
100% FULL TANK 14144 (6416) 316.6 (804)
80% FULL TANK 11315 (5132) 281.5 (715)
60% FULL TANK 8486 (3849) 255.6 (649)
40% FULL TANK 5658 (2566) 236.2 (600)
20% FULL TANK 2829 (1283) 217.5 (552)
2-50-3
THE MOVEMENT OF FUEL BETWEEN TANKS
Page 2-77 Jul 01/2005 D623N004
757
AIRPLANE RECOVERY DOCUMENT
Figure 2-35 ENGINE FUEL CROSSFEED INSTALLATION
2-50-3
THE MOVEMENT OF FUEL BETWEEN TANKS
Page 2-78 Jul 01/2005 D623N004
757 AIRPLANE RECOVERY DOCUMENT 2-50-4 When you Remove Fuel with External Power
1. You can use the electrical power from an external source to remove fuel from the airplane. Possibly the internal electrical system on the airplane is damaged. You can get the necessary power from a control unit (approved by Boeing) that connects the external power source to the boost pumps (see Figure 2-36).
2-50-4
WHEN YOU REMOVE FUEL WITH EXTERNAL POWER Page 2-79 Jul 01/2005
D623N004
THIS PAGE INTENTIONALLY LEFT BLANK
2-50-5 When you Remove Fuel with the Sump Drains
1.
The fuel sumps are installed at the lowest point of each tank (see Figure 2-37). The drain valves of these sumps permit you to remove bad material from the fuel tanks. They also permit you to remove the fuel that you cannot remove with the usual procedures.
2.
The drain valves are held in the closed position with a spring. You can operate a valve if you push it up and hold it against the spring. It is best if you use a 9/16-inch (14 mm) diameter tube.
In the center of the airplane, where the sump hose goes through the keel beam, there is a different procedure. You must hold the flexible hose and then you must push it up. You must use a special tool to lock the valve in the open position (see SUBJECT 5-10-1).
2-50-5
WHEN YOU REMOVE FUEL WITH THE SUMP DRAINS Page 2-81 Jul 01/2005
D623N004
757
AIRPLANE RECOVERY DOCUMENT
Figure 2-37 FUEL DRAINS
2-50-5
WHEN YOU REMOVE FUEL WITH THE SUMP DRAINS Page 2-82 Jul 01/2005
D623N004
2-60 REMOVAL OF LARGE COMPONENTS FROM THE AIRPLANE 2-60-1 Component Removal, Basic
1. If you must remove airplane components, the instructions are found in the applicable Maintenance Manual. Figure 2-12 shows the approximate data (weight/moment) to help you with the removal. Use the correct document (Weight and Balance Manual) for accurate component values. Here are some components that you can remove:
A. Damaged powerplants
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 Airplane Recovery Document 飞机恢复文件(52)
