757 MAINTENANCE MANUAL
MAIN GEAR TRUCK TILT SENSORS - MAINTENANCE PRACTICES
____________________________________________________
1. General_______
A. This procedure contains three tasks.
(1)
The first task removes the truck tilt sensors for the main landing gear.
(2)
The second task installs the truck tilt sensors on the main landing gear.
(3)
The third task does a test for the truck tilt sensors on the main landing gear.
TASK 32-09-07-002-001
2. Remove the Truck Tilt Sensors for the Main Landing Gear_______________________________________________________
A. Equipment
(1)
Pin Insertion/Extraction Tool
Part on Crimp Tool Kit - DMC 567
Daniels Manufacturing Corp.
526 Thorpe Road
Orlando, Forida 32824
B.
References
(1)
AMM 24-22-00/201, Electrical Power - Control
(2)
AMM 32-00-20/201, Landing Gear Downlocks
(3)
AMM 32-09-02/201, Prepare the Safety-Sensitive Systems for Air Mode Simulation
C.
Access
(1)
Location Zones
731/741 Main Landing Gear
D.
Prepare to Remove the Truck Tilt Sensor
S 492-002
(1)
Make sure the downlocks are installed on the nose and main landing gear (AMM 32-00-20/201).
(2)
Make sure the chocks are below the wheels.
S 492-003
32-09-07
ALL ú ú 01 Page 201 ú May 28/99
A
757 MAINTENANCE MANUAL
S 862-068
WARNING: MAKE SURE YOU DO THE STEPS TO PREPARE THE SYSTEMS FOR AIR MODE
_______ CORRECTLY. IF YOU DO NOT FOLLOW THESE INSTRUCTIONS, INJURIES TO PERSONS OR DAMAGE TO EQUIPMENT CAN OCCUR.
(3)
Do the task to prepare the safety-sensitive systems for air mode simulation (AMM 32-09-02/201).
S 212-037
(4)
Look at the sensor, its mounting bracket and the target for signs of damage or corrosion between the sensor and the shim.
NOTE: Check the shims for signs of corrosion and repair as
____ necessary. Refer to Service Letter 757-SL-32-057 for more data.
(a)
Make a record if damage is found. This data will be used during the installation.
E.
Remove the Truck Tilt Sensor (Fig. 201)
S 032-005
(1) Remove the bolts which hold the covers to the J-1 or the J-2 junction box.
NOTE: The junction box is on the truck beam of the main landing
____
gear.
S 862-006
CAUTION: WRITE DOWN THE COLOR CODE AND THE PIN LOCATION OF THE SENSOR
_______ WIRES BEFORE YOU DISCONNECT THE WIRES. THIS WILL MAKE THE INSTALLATION OF THE WIRES EASIER AND WILL PREVENT THE MALFUNCTION OF THE AIR/GROUND RELAY SYSTEM.
(2)
Put a tag with the color code and the pin locations on the sensor wires.
S 032-007
(3)
Use a pin extraction tool, to remove the sensor wire from the terminal block in the junction box.
(4)
Put a line on the sensor wires to make the installation easier.
(5)
Disconnect the conduit coupling nut from the sensor (1).
S 862-008
S 032-009
32-09-07
ALL ú ú 01 Page 202 ú May 28/99
A
757
MAINTENANCE MANUAL
TRUCK BEAM (REF)
4. NUT
3. SHIM
1. SENSOR BRACKET FOR THE MOUNTING
TARGET (REF) SENSOR (REF)
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 AMM 飞机维护手册 起落架 CHAPTER 32 - LANDING GEAR 1(61)
