(a)
Look for one or more of the conditions that follow to find signs of possible corrosion under the chrome plating: 1) Poor chrome bonds with the base metal. 2) Bubbles in the chrome plating. 3) An area of chrome plate that moves above the smooth surface
of the adjacent chrome plate when you move the dental
explorer across it.
4) Chrome plate that comes off in flakes when you move the dental explorer over the chrome plate. If any of these conditions are present the inner cylider is not serviceable.
32-00-03
ALL ú ú 01 Page 603 ú May 28/00
A
757 MAINTENANCE MANUAL
CAUTION: MAKE SURE THE SUBSEQUENT INSPECTIONS CHECK THE REPAIR
_______ UNTIL THE SHOCK STRUT IS OVERHAULED. CONTINUED USE OF A LANDING GEAR WITH THE REPAIR FOR CRACKING CHROME MAY RESULT IN SEAL DAMAGE, SHOCK STRUT FLUID CONTAMINATION, AND POSSIBLE STRUT PRESSURE LOSS. THERE IS NO PERMANENT REPAIR FOR CRACKED CHROME, THE CRACK WILL REMAIN UNTIL THE CHROME IS REMOVED AND REPLACED.
(b) After the temporary repair is done, make sure the inspection procedure (AMM 32-00-03/601) is done between four and six months again, and again until the shock strut is removed and replaced. Once chrome is damaged, there is no permanent repair, and the damage can continue to spread. The only permanent repair is to strip and replate the chrome. 1) Measure the size of the area that has the cracks, and make
a sketch of the location and shape of the area, and mark the dimensions on the sketch. Make sure you keep this data so it can be used for the next inspection.
2) Use a wiper to apply a thick layer of primer to the cracked chrome surface.
3) Before the primer dries, remove the excess with a clean, dry cloth. Make sure no primer gets on the seals or scrapers, as they can be damaged by the primer and may start to leak.
4) Let the primer cure for at least 4 hours.
F. Put the Airplane back to its Usual Condition
S 016-007
WARNING: YOU MUST CAREFULLY DO THE STEPS WHEN YOU REMOVE THE DOOR LOCKS
_______ FROM THE LANDING GEAR DOORS. THE DOORS CAN CLOSE QUICKLY IF YOU DO NOT REMOVE THE DOOR LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(1) Do this task: "Removal of the Door Locks from all Landing Gear Doors." (AMM 32-00-20/201).
32-00-03
ALL ú ú 01 Page 604 ú May 28/00
A
757
MAINTENANCE MANUAL
LANDING GEAR CONTROL CABLES - MAINTENANCE PRACTICES
___________________________________________________
1. General_______
A. This procedure gives the data to get the location and to make all of the control cables for the landing gear.
B. The control cables are put into three groups. These groups are:
(1)
Extension and retraction cables
(2)
Brake cables
(3)
Nose wheel steering cable
C.
There are no procedures for the removal, installation, or for the adjustment of the cables. Refer to 20-10-03/401 - Control Cables for procedures to do the removal or installation tasks. For the adjustment procedure, refer to the adjustment test procedure for the applicable system.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 AMM 飞机维护手册 起落架 CHAPTER 32 - LANDING GEAR 1(13)
