32-09-00
ALL ú ú 01 Page 106 ú Sep 20/94
A
757 MAINTENANCE MANUAL
AIR/GROUND RELAY SYSTEM - DESCRIPTION AND OPERATION
___________________________________________________
1. General (Fig. 1)_______
A. The air/ground relays provide various airplane systems control in two independent air ground sensing systems (system 1 and system 2). Air/ground sensing is provided by inputs from the nose gear not compressed sensors, main gear truck tilt sensors, and truck positioner actuator hydraulic inlet pressure switches. The relays energize or de-energize to provide equipment functions in ground or air mode. On most functions, either system 1 or 2 is used. However, critical airplane function may use both systems for air/ground sensing.
B. When the airplane is on the ground (main gear trucks not tilted, nose gear shock strut compressed, and truck positioner actuator hydraulic inlet pressue switches open) or in the air (main gear trucks tilted, nose gear shock strut extended, and inlet pressure switches closed), the proximity sensors provide air/ground signal to a proximity switch electronics unit (PSEU). The PSEU converts sensor input into a signal output to the relay. The relay energizes or de-energizes to provide ground or air mode condition. Air/ground system 1 or air/ground system 2 each consists of a number of relays, nose gear not compressed sensor, and left and right main gear truck tilt sensors. All relays are 4-pole, double-throw, rated at 2 or 10 amperes.
C. GUN 051; The relays are located in P33, P36 and P37 relay panels in the main E/E compartment.
D. GUN 001-010 AND GUN 101-999; The relays are located in P36 and P37 relay panels in the main E/E compartment.
2. Component Details
_________________
A. Air/Ground Relays (Fig. 2)
_________________
(1) All system 1 and system 2 air/ground control relays are 4-pole, double-throw, 2 or 10 amp-rated, hermetically sealed relays with pin-type terminals for electrical plug connections. The relays energize or de-energize to provide a ground or air mode condition to the airplane. System 1 relays are located in P36 panel. System 2 relays are located in P37 panel.
32-09-02
ALL ú ú 04 Page 1 ú Jun 20/97
A
757
MAINTENANCE MANUAL
NOSE GEAR
STRUT (REF) MAIN GEARTILT SENSOR
INPUT
INPUT
NOSE GEAR NOT
COMPRESSED
SENSORS
PROXIMITY SWITCH
ELECTRONIC UNIT
OUTPUT
AUTO SPEED BRAKES
AUTO BRAKES
RAT
THRUST REVERSERS
PITOT HEAT
OUTPUT
STALL WARNING
RELAY
CARGO DOOR (EXAMPLE)
FOOT HEATERS
EXTERNAL POWER
PACS
FCC
AIR/GROUND RELAY PANEL
(EXAMPLE)
AIRCRAFT SYSTEMS (EXAMPLE) (P33, P36 OR P37)
Air/Ground Sensing
Figure 1
32-09-02
ALL ú ú 01 Page 2 ú May 20/98
A
757
MAINTENANCE MANUAL
RELAY IN THIS PANEL INSTALLED ON SOME AIRPLANES, SEE COMPONENT LOCATION FOR APPLICATION
Air/Ground Relays Location Figure 2
32-09-02
ALL ú ú 01 Page 3 ú Sep 20/93
A
757
MAINTENANCE MANUAL
(2)
GUN 051;
Relay K144, a system 1 relay, is in the P33 panel.
B.
Nose Gear Not Compressed Sensors (Fig. 1)
________________________________
(1)
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 AMM 飞机维护手册 起落架 CHAPTER 32 - LANDING GEAR 1(26)
