S 094-021
WARNING: USE THE PROCEDURE IN AMM 32-00-15/201 TO REMOVE THE DOOR LOCKS.
_______ THE DOORS OPEN AND CLOSE QUICKLY AND CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(3) Remove the door locks from the landing gear doors and close the doors (AMM 32-00-15/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH TWO PIECE TANG ATTACHMENT ú
32-12-02
DROP LINK ú
ú 01A ú Page 405May 28/99
A
757 MAINTENANCE MANUAL
MAIN GEAR STRUT DOOR - REMOVAL/INSTALLATION
___________________________________________
1. General
_______
A. This procedure contains two tasks. The first task removes the strut door for the main landing gear. The second task installs the strut door for the main landing gear.
TASK 32-12-04-004-001
2. Remove the Strut Door for the Main Landing Gear (Fig. 401)
_______________________________________________
A. References
(1)
AMM 32-00-15/201, Landing Gear Door Locks
(2)
AMM 32-00-20/201, Landing Gear Downlocks
B.
Access
(1)
Location Zones
731/741 Main Landing Gear (MLG)
732/742 MLG Body Doors
733/743 MLG Oleo Doors
C.
Prepare for the Removal of the Strut Door
S 494-002
(1) Make sure the downlocks are installed on the nose and main landing gear (AMM 32-00-20/201).
S 494-021
WARNING: USE THE PROCEDURE IN AMM 32-00-15/201 TO INSTALL THE DOOR
_______ LOCKS. THE DOORS OPEN AND CLOSE QUICKLY AND CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(2)
Open the doors for the landing gear and install the door locks (AMM 32-00-15/201).
D.
Remove the Strut Door
(1)
Hold the strut door.
S 844-004
32-12-04
ALL ú ú 01 Page 401 ú Sep 28/99
A
757
MAINTENANCE MANUAL
5. STRUT DOOR
Strut Door Installation for the Main Landing Gear
Figure 401 (Sheet 1)
32-12-04
ALL ú ú 01 Page 402 ú May 28/99
A
757
MAINTENANCE MANUAL
14. LEVER ARM
18. BOLTS
ATTACH BOLTS
19. WASHERS
39. BOLT 15. WASHERS
20. WASHERS
40. WASHER 16. WASHERS
43. BOLT 47. BOLT
21. NUTS
17. NUTS
Strut Door Installation for the Main Landing Gear
Figure 401 (Sheet 2)
32-12-04
ALL ú ú 01 Page 403 ú May 28/99
A
757 MAINTENANCE MANUAL
(2) S 014-005Remove the bolt to disconnect the pushrod for the trunnion door from the attach fitting on the strut door.
(3) S 014-006Remove the attach bolt (6) to disconnect the strut door at its lower fitting from the lower adjustable link (Detail B).
(4) S 014-007Remove the attach bolts (1) to disconnect the strut door from the center support equalizer fitting on the drag strut center fitting (Detail A).
(5) S 014-008Remove the attach bolts (14, 18, 25, 28, 32, 35, 39, 43, and 47) for the beam and the lever arm. This disassembles the support beam for the door from the door (Detail D).
(6) S 014-009Remove the attach bolt (10) to disconnect the strut door from the upper support fitting at the trunnion link (Detail C).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 AMM 飞机维护手册 起落架 CHAPTER 32 - LANDING GEAR 1(157)
