S 825-053
(22)
If the door is not aligned with the wing at point 3, do the steps that follow:
(a)
Move the control lever to the DN position,to extend the landing gear.
(b)
Install the downlock.
(c)
Move the washers at the forward door stop (Detail F).
(d)
Move the control lever to the UP position, to retract the landing gear.
(e)
Put the control lever OFF.
32-12-00
ALL ú ú 05 Page 523 ú Sep 28/01
A
757 MAINTENANCE MANUAL
(f)
Measure the clearance at point 3.
(g)
If the door and the wing are not aligned, do the procedure again.
S 035-054
(23)
Remove the wing access panel 571BB, left (671BB, right) for access to the pushrod for the trunnion fairing door (AMM 06-44-00/201).
S 825-055
(24)
Adjust the pushrod for the trunnion fairing door (see the procedure Adjustment - Trunnion Fairing Door for the Main Landing Gear).
S 845-056
(25)
Move the control lever to the DN position, to extend the landing gear.
S 495-057
(26)
Install the downlock (AMM 32-00-15/201).
S 585-058
(27)
Lower the airplane and remove the jacks (AMM 07-11-01/201).
S 095-088
WARNING:_______OBEY THE REMOVAL PROCEDURE FOR THE DOOR LOCKS. THE DOORS OPEN AND CLOSE QUICKLY. THE MOVEMENT OF THE DOORS CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
(28) Remove the door locks and close the doors (AMM 32-00-15/201).
TASK 32-12-00-825-060
4. Adjustment - Trunnion Fairing Door for the Main Landing Gear (Fig. 503)____________________________________________________________
A. General
(1) This procedure gives the instructions to adjust the trunnion fairing door.
32-12-00
ALL ú ú 05 Page 524 ú May 28/02
A
757
MAINTENANCE MANUAL
B. Equipment
(1)
Door Lock, Landing Gear - (AMM 32-00-15/201)
(2)
Downlock, MLG and NLG - B32001-1
C.
Consumable Materials
(1)
A00247 Sealant, Chromate - BMS 5-95
D.
References
(1)
06-44-00/201, Wing Access Doors and Panels
(2)
07-11-01/201, Jacking Airplane
(3)
29-11-00/201, Main (Left, Right, and Center) Hydraulic Systems
(4)
32-00-15/201, Landing Gear Door Locks
(5)
32-00-20/201, Landing Gear Downlocks
E.
Access
(1)
Location Zones
731/741 Main Landing Gear (MLG)
732/742 MLG Body Doors
733/743 MLG Oleo Door
(2)
Access Panels
551BB Left Wing Access Panel
651BB Right Wing Access Panel
F.
Prepare for the Adjustment
S 495-061
(1) Make sure the downlocks are installed on the nose and main landing gear (AMM 32-00-20/201).
S 495-062
WARNING:_______OBEY THE INSTALLATION PROCEDURE FOR THE DOOR LOCKS. THE DOORS OPEN AND CLOSE QUICKLY. THE MOVEMENT OF THE DOORS CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
(2) Open the doors for the landing gear and install the door locks (AMM 32-00-15/201).
32-12-00
ALL ú ú 05 Page 525 ú Sep 28/01
A
757
MAINTENANCE MANUAL
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 AMM 飞机维护手册 起落架 CHAPTER 32 - LANDING GEAR 1(151)
