• 热门标签

当前位置: 主页 > 航空资料 > 飞行资料 >

时间:2010-10-21 23:27来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

airspeeds below 95 KIAS.
5. Flap deflection is limited to 50% during autopilot operations.
6. The autopilot must be disconnected in moderate or severe
turbulence.
7. Minimum engage height for the autopilot is 400 ft AGL.
8. Minimum speed with the autopilot engaged is 1.2Vs for the given
configuration.
9. For VOR/GPS and ILS glideslope and localizer intercept, capture,
and tracking, the following limitations apply:
a. The autopilot must be disengaged no later than 100 feet below
the Minimum Descent Altitude.
b. The autopilot must be disconnect during approach if course
deviation exceeds 50%. The approach should only be
continued by “hand-flying” the airplane.
c. 12 knot maximum crosswind component between the missed
approach point and outer marker.
d. The intercept of the localizer shall occur at least 5 miles
outside of the outer marker.
e. If the crosswind component is greater than 12 knots and less
than 17 knots, the intercept shall occur at least 10 miles
outside of the outer marker.
f. The intercept angle shall be no greater than a 45-degree
intercept.
Revision 3: 07-18-05
4 of 16 P/N 11934-S08
Section 9 Cirrus Design
Supplements SR20
g. The ILS is flown at normal approach speeds, and within any
STC or TC speed constraints and as defined in this flight
manual.
h. The flaps should be extended in the approach configuration
prior to the Outer Marker. No further changes in the flap
configuration should be made throughout the autopilotcoupled
approach.
i. The glideslope is approached in such a manner to allow
automatic arming of the glideslope, or if the glideslope is
manually armed no more than 15% above the glideslope.
10. The S-TEC System Fifty Five X Pilot’s Operating Handbook, P/N
8747 dated 03/99 or later, must be carried in the airplane at all
times and must be available to the pilot while in flight.
Revision 3: 07-18-05
P/N 11934-S08 5 of 16
Cirrus Design Section 9
SR20 Supplements
HDG NAV APR REV ALT VS
S-TEC
AP
SR2_FM09_1111
HDG NAV APR REV TRIM ALT GS VS + 18 R
DY
C
WS
F
L
AI
Figure - 1
System 55 Autopilot Programmer/Computer
Revision 3: 07-18-05
6 of 16 P/N 11934-S08
Section 9 Cirrus Design
Supplements SR20
Section 3 - Emergency Procedures
Autopilot Malfunction
Refer to Electric Trim/Autopilot Failure procedure in the SR20 POH. Do
not reengage the autopilot until the malfunction has been identified
and corrected. The autopilot may be disconnected by:
1. Pressing the A/P DISC/Trim switch on the control yoke handle.
2. Pulling the AUTOPILOT circuit breaker on the Main Bus 1.
Altitude lost during a roll axis autopilot malfunction and recovery:
Altitude lost during a pitch axis autopilot malfunction and recovery:
Flight Phase Bank Angle Altitude Loss
Climb 30° None
Cruise 55° 100 ft
Descent 55° 120 ft
Maneuvering 10° None
Approach 0° 20 ft
Flight Phase Altitude Loss
Cruise 200 ft
ILS 25 ft
Revision 3: 07-18-05
P/N 11934-S08 7 of 16
Cirrus Design Section 9
SR20 Supplements
System Failure and Caution Annunciations
If any of the following failure annunciations occur at low altitude or
during an actual instrument approach, disengage the autopilot,
execute a go-around or missed approach as appropriate. Inform ATC
of problem. Do not try to troubleshoot until a safe altitude and
maneuvering area are reached or a safe landing is completed.
Annunciation Condition Action
Flashing RDY for 5
seconds with
audible tone.
Autopilot disconnect. All
annunciations except RDY
are cleared.
None.
Flashing RDY with
audible tone then
goes out.
Turn coordinator gyro
speed low. Autopilot
disengages and cannot be
re-engaged.
Check power to turn
coordinator.
Flashing NAV,
REV, or APR.
Off navigation course by
50% needle deviation or
more.
Use HDG mode until
problem is identified.
Crosscheck raw NAV
data, compass heading,
and radio operation.
Flashing NAV,
REV, or APR with
steady FAIL
Invalid radio navigation
signal.
Check Nav radio for
proper reception. Use
HDG mode until problem
is corrected.
Flashing VS Excessive vertical speed
error over selected vertical
speed. Usually occurs in
climb.
Reduce VS command
and/or adjust power as
appropriate.
Flashing GS Off glideslope centerline by
50% needle deviation or
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:Cirrus Design SR20西锐20飞行员操作手册和飞机飞行手册附录(18)