C.
Procedure
S 864-086
(1) Set the parking brake.
S 494-109
WARNING: USE THE PROCEDURE IN AMM 32-00-15/201 TO REMOVE THE DOOR LOCKS.
_______ THE DOORS OPEN AND CLOSE QUICKLY AND CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(2)
Remove the door locks from the landing gear doors and close the doors (AMM 32-00-15/201).
D.
Procedure
S 414-104
(1)
Install the access panel for the E5 rack on the forward bulkhead of the forward cargo compartment (AMM 25-50-03/401).
(2)
Close the forward cargo door, 821.
S 864-106
(3)
Remove the power from the right hydraulic system if it is not necessary (AMM 29-11-00/201).
(4)
Remove electrical power if it is not necessary (AMM 24-22-00/201).
S 414-105
S 864-107
32-42-09
ALL ú ú 09 Page 413 ú Jan 28/01
A
757
MAINTENANCE MANUAL
AUTOBRAKE SHUTTLE VALVE MODULE AND COMPONENTS - REMOVAL/INSTALLATION
____________________________________________________________________
1. General
_______
A. The valve assembly is a module that consists of a shuttle valve, a pressure switch, and the module housing. This procedure contains six tasks to remove and install the module and components as follows:
(1)
Autobrake Shuttle Valve Module - Removal
(2)
Autobrake Shuttle Valve Module - Installation
(3)
Autobrake Shuttle Valve - Removal
(4)
Autobrake Shuttle Valve - Installation
(5)
Autobrake Shuttle Valve Pressure Switch - Removal
(6)
Autobrake Shuttle Valve Pressure Switch - Installation
TASK 32-42-10-944-001
2. Prepare for Removal
___________________
A. References
(1)
06-46-00/201, Entry, Service and Cargo Doors
(2)
24-22-00/201, Electrical Power - Control
(3)
25-50-03/401, Bulkhead Lining
(4)
29-11-00/201, Pressurize/Depressurize Main Hydraulic Systems
(5)
32-00-15/201, Landing Gear Door Locks
(6)
32-00-20/201, Landing Gear Downlocks
(7)
34-21-00/501, Inertial Reference System
B.
Access
(1)
Location Zones
211 Control Cabin, Left
212 Control Cabin, Right
731 Landing Gear Left
741 Landing Gear Right
120 Main Equipment Center, Right
TASK 32-42-10-024-002
3. Autobtrake Shuttle Valve Module - Removal
__________________________________________
A. References
(1)
32-00-15/201, Landing Gear Door Locks
(2)
32-00-20/201, Landing Gear Downlocks
(3)
24-22-00/201, Electrical Power - Control
(4)
29-11-00/201, Pressurize/Depressurize Main Hydraulic Systems
32-42-10
ALL ú ú 01 Page 401 ú Mar 20/91
A
757
MAINTENANCE MANUAL
AUTOBRAKE SHUTTLE VALVE ASSEMBLY
SEE B
HYDRAULIC RESERVOIR (REF)
AUTOBRAKEAUTOBRAKE SHUTTLE VALVE
MODULELOCATED ON WHEEL WELL FORWARD BULKHEAD
SEE A FORWARD BULKHEAD OUTBD
(REF)
FWD
LEFT WHEEL WELL SHOWN, RIGHT WHEEL WELL EQUIVALENT
A
HYDRAULIC
LINE (EXAMPLE)
MOUNTING
(3 LOCATIONS) BRACKET
VALVE
NUT
WASHER
(3 LOCATIONS)
WHEEL WELL FORWARD BULKHEAD
BOLT
WASHER
(3 LOCATIONS)
FWD
ELECTRICAL
INBD CONNECTOR
LEFT AUTOBRAKE SHUTTLE VALVE ASSEMBLY INSTALLATION SHOWN RIGHT AUTOBRAKE SHUTTLE VALVE ASSEMBLY INSTALLATION EQUIVALENT (SEE SHT 2 FOR COMPONENTS)
B
Autobrake Shuttle Valve Module/Component Installation
Figure 401 (Sheet 1)
32-42-10
ALL ú ú 01 Page 402 ú Sep 20/90
A
757 MAINTENANCE MANUAL HYDRAULIC LINE
SHUTTLE VALVE
RETAINER (EXAMPLE) O-RING (EXAMPLE)
FORWARD BULKHEAD WHEEL WELL
VALVE
O-RING
PRESSURE SWITCH ELECTRICAL CONNECTOR
AUTOBRAKE SHUTTLE VALVE - MODULE COMPONENTS
B
Autobrake Shuttle Valve Module/Components Installation
Figure 401 (Sheet 2)
32-42-10
ALL ú ú 01 Page 403 ú Sep 20/90
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 AMM 飞机维护手册 起落架 CHAPTER 32 - LANDING GEAR 3(48)
