d) Push the TARGET TEST switch and hold for one second.
e) Make sure the correct sensor number is shown on the LED display, and, after four seconds, the TARGET NEAR light comes on.
f) Remove the actuator from the sensor.
Do the test of the up and locked sensor with the uplock
_______________ hook in the up and locked position.
__________________________________
NOTE: This test is not necessary after a sensor
____ installation. You can use this test to find if a sensor will change from target near to target far.
a) Push the TARGET TEST switch and hold for one second.
b) Make sure the sensor number is shown on the LED display, and, after four seconds, the TARGET FAR light comes on.
c) Manually apply force to the uplock hook to put the hook in the locked position.
d) Push the TARGET TEST switch for one second.
e) Make sure the sensor number is again shown and, after four seconds, the TARGET NEAR light comes on.
32-61-02
ALL ú ú 03 Page 214 ú Mar 20/93
A
757 MAINTENANCE MANUAL
5) Do the test of the door sensor with the door closed.
___________________________
NOTE: This test is not necessary after a sensor
____ installation. You can use this test to find if a sensor will change from target near to target far.
a) Push the TARGET TEST switch and hold for one second.
b) Make sure the correct sensor number is shown on the LED display, and after four seconds, the TARGET FAR light comes on.
WARNING: OBEY THE REMOVAL PROCEDURE FOR THE DOOR LOCKS.
_______ THE DOORS OPEN AND CLOSE QUICKLY. THE MOVEMENT OF THE DOORS CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
c) Remove the door locks and close the doors
(AMM 32-00-15/201). d) Push the TARGET TEST switch for one second. e) Make sure the correct sensor number is shown, and after
four seconds, the TARGET NEAR light comes on.
G. Put the Airplane Back to Its Initial Condition
S 092-048
WARNING:_______OBEY THE REMOVAL PROCEDURE FOR THE DOOR LOCKS. THE DOORS OPEN AND CLOSE QUICKLY. THE MOVEMENT OF THE DOORS CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
(1)
Remove the door locks and close the doors (AMM 32-00-15/201).
S 862-047
(2)
Remove electrical power (AMM 24-22-00/201) if it is not necessary.
(3)
Close the access door for the main equipment center, 119BL.
S 412-049
TASK 32-61-02-822-013
5. Adjustment - Proximity Sensor for the Main Landing Gear
_______________________________________________________
A. Consumable Materials
(1)
G02020, Soft modeling clay
(2)
G00961, Talcum powder
32-61-02
ALL ú ú 01 Page 215 ú Sep 28/01
A
757
MAINTENANCE MANUAL
B. References
(1)
24-22-00/201, Electrical Power - Control
(2)
32-00-15/201, Landing Gear Downlocks
C.
Access
(1)
Location Zones
143 MLG Wheel Well (Left)
144 MLG Wheel Well (Right)
731 Main Landing Gear (MLG) (Left)
741 Main Landing Gear (MLG) (Right)
D.
Procedure
S 822-014
(1)
Do the steps that follow to adjust the landing gear down and locked sensors (Fig. 201):
(a)
Make sure the clearance between the sensors and the targets is within the limits shown on Fig. 201. 1) If the clearance is in the limits, do the test of the
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 AMM 飞机维护手册 起落架 CHAPTER 32 - LANDING GEAR 3(163)
