1EFF : ALL 1 34-52-00Page 510 1 1 Nov 01/04 1 1 1CES 1
-------------------------------------------------------------------------------
REFERENCE DESIGNATION -------------------------------------------------------------------------------
34-52-00-720-005 Functional Test of the ATC/Mode S Transponder
3. Job Set-up
__________ R **ON A/C 106-149, 221-299, 301-399, 401-499,
Subtask 34-52-00-800-051
A. Aircraft Configuration NOTE : When the aircraft transponders can operate in Elementary
____
Surveillance or Enhanced Surveillance mode, do the functional test R of the ATC/Mode S transponder. Refer to TASK 34-52-00-720-005-02 R (Ref. TASK 34-52-00-720-005).
**ON A/C ALL
Subtask 34-52-00-860-083
B. Aircraft Maintenance Configuration
(1)
Energize the aircraft electrical circuits
(Ref. TASK 24-41-00-861-002).
(2)
Do the ADIRS start procedure (Ref. TASK 34-10-00-860-002).
(3)
On the center pedestal:
(a)
On the ATC/TCAS control unit, set:
-
the ATC system 1(2) on.
-
the ATC code 5555 to keep the traffic interference to a minimum.
-
the ALT RPTG ON/OFF switch to ON.
-
the ON/AUTO/STBY switch to ON.
(b)
On the SWITCHING panel 8VU:
-make sure that the AIR DATA selector switch is at NORM.
1EFF : ALL 1 34-52-00Page 511 1 1 Aug 01/05 1 1 1CES 1
Subtask 34-52-00-865-057
R C. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU COM NAV/ATC/1 5SH1 G11 121VU COM NAV/ATC/2 5SH2 K07
Subtask 34-52-00-480-050
R D. Install the T49 - ATC GROUND TEST UNIT (or equivalent) in the cockpit.
(1) Connect the test antenna to the test unit.
(2) Put the test antenna near the ATC antenna for which you do the test (approx. 2 ft.).
NOTE : Use an access platform or a telescopic pole to put the test____ antenna near the ATC bottom antenna.
Subtask 34-52-00-860-073
R E. Obey the applicable safety precautions before you open the LGCIU circuit breakers (Ref. TASK 32-00-00-860-001).
Subtask 34-52-00-865-061
R F. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU L/G/LGCIU/SYS1/NORM 1GA C09 121VU HYDRAULIC/LGCIU/SYS2 2GA Q35 121VU HYDRAULIC/LGCIU/SYS1/GRND SPLY 52GA Q34
R 1EFF : ALL 1 34-52-00Page 512 1 1 May 01/05 1 1 1CES 1
4. Procedure
_________ Subtask 34-52-00-720-051-A
A. Functional Test of the ATC/Mode S Transponder
NOTE : Do the test of the ATC bottom antenna 1(2) first.
____
Then, do the test of the ATC top antenna 1(2).
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the ATC ground test unit: On the ATC ground test unit:
- set the ATCRBS/MODE S/TCAS/XPDR
TEST switch to XPDR TEST.
- push the TEST pushbutton switch - the data display shows:
to start the operation of the MODE S XPDR COM A/B
test set. INTERROGATE TO TEST.
NOTE : You can also start the____
same test procedure if you
push the INTERROGATE
pushbutton switch. At the
end of this test
procedure, a test message
shows the system status
but all the results given
below are not shown.
- push the TEST pushbutton - the data display shows:
switch. ATCRBS/A
TESTING
and then,
ATCRBS/A
5555 XX% REPLY
(XX is a number which indicates the
local conditions of reception).
NOTE : You must do the steps that____
follow in a fast sequence
to keep incorrect traffic
alarms to a minimum.
2. On the ATC/TCAS control unit:
1EFF : ALL 1 34-52-00Page 513 1 1 May 01/05R 1 1 1CES 1
-------------------------------------------------------------------------------
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM NAVIGATION 导航4(128)
