曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
number of degrees clockwise from the nose of the aircraft
to the station being received.
Automatic terminal information service (ATIS). The
continuous broadcast of recorded non-control information in
selected terminal areas. Its purpose is to improve controller
effectiveness and relieve frequency congestion by automating
repetitive transmission of essential but routine information.
Aviation medical examiner (AME). A physician with
training in aviation medicine designated by the Civil
Aerospace Medical Institute (CAMI).
AWOS. See automated weather observing system.
Azimuth card. A card that may be set, gyroscopically
controlled, or driven by a remote compass.
Back course (BC). The reciprocal of the localizer course
for an ILS. When flying a back-course approach, an aircraft
approaches the instrument runway from the end at which the
localizer antennas are installed.
Baro-aiding. A method of augmenting the GPS integrity
solution by using a non-satellite input source. To ensure that
baro-aiding is available, the current altimeter setting must
be entered as described in the operating manual.
Barometric scale. A scale on the dial of an altimeter to which
the pilot sets the barometric pressure level from which the
altitude shown by the pointers is measured.
BC. See back course.
Block altitude. A block of altitudes assigned by ATC to
allow altitude deviations; for example, “Maintain block
altitude 9 to 11 thousand.”
Cage. The black markings on the ball instrument indicating
its neutral position.
Calibrated. The instrument indication compared with a
standard value to determine the accuracy of the instrument.
Calibrated orifice. A hole of specific diameter used to delay
the pressure change in the case of a vertical speed indicator.
G-4
Calibrated airspeed. The speed at which the aircraft
is moving through the air, found by correcting IAS for
instrument and position errors.
CAS. Calibrated airspeed.
CDI. Course deviation indicator.
Changeover point (COP). A point along the route or
airway segment between two adjacent navigation facilities
or waypoints where changeover in navigation guidance
should occur.
Circling approach. A maneuver initiated by the pilot to
align the aircraft with a runway for landing when a straightin
landing from an instrument approach is not possible or is
not desirable.
Class A airspace. Airspace from 18,000 feet MSL up to and
including FL 600, including the airspace overlying the waters
within 12 NM of the coast of the 48 contiguous states and
Alaska; and designated international airspace beyond 12 NM
of the coast of the 48 contiguous states and Alaska within areas
of domestic radio navigational signal or ATC radar coverage,
and within which domestic procedures are applied.
Class B airspace. Airspace from the surface to 10,000 feet
MSL surrounding the nation’s busiest airports in terms of
IFR operations or passenger numbers. The configuration of
each Class B airspace is individually tailored and consists
of a surface area and two or more layers, and is designed to
contain all published instrument procedures once an aircraft
enters the airspace. For all aircraft, an ATC clearance is
required to operate in the area, and aircraft so cleared receive
separation services within the airspace.
Class C airspace. Airspace from the surface to 4,000 feet
above the airport elevation (charted in MSL) surrounding
those airports having an operational control tower, serviced
by radar approach control, and having a certain number of IFR
operations or passenger numbers. Although the configuration
of each Class C airspace area is individually tailored, the
airspace usually consists of a 5 NM radius core surface area
that extends from the surface up to 4,000 feet above the airport
elevation, and a 10 NM radius shelf area that extends from
1,200 feet to 4,000 feet above the airport elevation.
Class D airspace. Airspace from the surface to 2,500 feet
above the airport elevation (charted in MSL) surrounding
those airports that have an operational control tower. The
configuration of each Class D airspace area is individually
tailored, and when instrument procedures are published, the
airspace is normally designed to contain the procedures.
Class E airspace. Airspace that is not Class A, Class B, Class
C, or Class D, and is controlled airspace.
Class G airspace. Airspace that is uncontrolled, except
when associated with a temporary control tower, and has
not been designated as Class A, Class B, Class C, Class D,
or Class E airspace.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
Instrument Flying Handbook仪表飞行手册下(102)
