(2) Do the operational test of the automatic change-over function (Ref. AMM TASK 22-60-00-710-002).
4. Fault Isolation
_______________
A. If the operational test of the AFS gives the maintenance message AFS: FAC 2/RTL ENGD FDBK:
(1) If the operational test of the automatic change-over function gives the maintenance message AFS: FAC 1/RTL ENGD CHG-OV:
- replace the FAC-2 (1CC2), (Ref. AMM TASK 22-66-34-000-002) and (Ref. AMM TASK 22-66-34-400-002).
(a) If the fault continues:
- do a check and repair the wiring of the RTL ENGD COM and RTL ENGD MON discretes from the FAC 2 (1CC2) to the first terminal block (Ref. ASM 22-68/02).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞22-61-00∞∞∞∞∞∞∞∞∞∞Page 203
Feb 01/98 CES
(2) If there is no message after the operational test of the automatic change-over function:
- replace the FAC 2 (1CC2) (Ref. AMM TASK 22-66-34-000-002) and (Ref. AMM TASK 22-66-34-400-002).
(a) If the fault continues:
- do a check and repair the wiring of the RTL OWN ENGD COM and RTL OWN ENGD MON discretes from the FAC 2 (1CC2) to the first terminal block (Ref. ASM 22-68/02).
B. Do the operational test given in Para. 3.A.(1).
Loss of the Rudder Travel Limiting Function on the FAC 1
1. Possible Causes
_______________
- LIMITATION UNIT-RUDDER TRAVEL (4CC)
- RELAY-RTL SYS1 (13CC1)
- FAC-1 (1CC1) R - SENSOR-TAT, 1 (11FP1)
- wiring for 28VDC signal (pin A2) and GND signal (pin X2) at the relay (13CC1)
- wiring of the RTL ACT VALID signal from the FAC1 to the RTLU and associated GND signal at the RTLU
- electronic module
- wiring of the RTL ACT PWR ON signal from the FAC1 to the relay 13CC1
- wiring of the 28VDC and GND at the RTLU (PWR SPLY)
- wiring from the FAC 1 (1CC1) to the rudder travel-limitation unit (4CC)
- wiring of the RTL V1 and RTL V2 discretes from the FAC 1 (1CC1) to the rudder travel-limitation unit (4CC)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 22-61-00-710-001 Operational Test of the Rudder Travel Limiting
Function AMM 22-66-34-000-002 Removal of the FAC (1CC1,1CC2) AMM 22-66-34-400-002 Installation of the FAC (1CC1,1CC2) AMM 22-96-00-710-001 Operational Test of the AFS AMM 27-23-51-000-001 Removal of the Rudder Travel Limitation Unit 4CC AMM 27-23-51-000-002 Removal of the Electronic Module of the Rudder Travel
Limitation Unit AMM 27-23-51-400-001 Installation of the Rudder Travel Limitation Unit 4CC AMM 27-23-51-400-002 Installation of the Electronic Module of the Rudder
Travel Limitation Unit R AMM 34-11-18-000-001 Removal of the TAT Sensor (11FP1, 11FP2) R AMM 34-11-18-400-001 Installation of the TAT Sensor (11FP1, 11FP2)
ASM 22-67/01
ASM 22-68/02
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞22-61-00∞∞∞∞∞∞∞∞∞∞Page 205
Nov 01/04 CES
3. Fault Confirmation
__________________
A. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU AUTO FLT/FAC1/28VDC 5CC1 B04
B. Test
(1) Open the circuit breaker 5CC1.
(2) After a minimum of 10 seconds, close the circuit breaker 5CC1.
(3) After 2 minutes, do the operational test of the AFS (Ref. AMM TASK 22-96-00-710-001) and read the result for the FAC 1.
4. Fault Isolation
_______________
A. If the test gives the maintenance message AFS : FAC1/RTL ACTR 4CC:
- remove the relay 13CC1 (open the circuit breaker 5CC1 before and close it after)
- do a check of the correct wiring for 28VDC signal (pin A2) and GND signal (pin X2) at the relay (13CC1), if no repair it (Ref. ASM 22-68/02)
- open the circuit breaker 5CC1
- remove the FAC-1 (1CC1) (Ref. AMM TASK 22-66-34-000-002)
- install the above removed relay (13CC1).
(1) Do a check of the impedance of the RTL ACT VALID signal between the pin AB/11A and the pin AC/3 (GND signal) of the FAC-1 rack connector, (Ref. ASM 22-68/02) and (Ref. ASM 22-67/01).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320 Trouble Shooting Manual 排故手册 AUTO FLIGHT 自动飞行1(87)
