曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
GPS (Corrected to UTC) - Available at all times to those crews who can access time via approved
on-board GPS (TSO-C129) equipment.
WWV - National Institute of Standards (NIST - Fort Collins, Colorado). WWV operates continually
H24 on 2500, 5000, 10,000, 15,000 and 20,000 kHz (AM/SSB) and provides UTC (voice) once
every minute.
CHU - National Research Council (NRC - Ottawa, Canada) - CHU operates continually H24 on
3330, 7335 and 14,670 kHz (SSB) and provides UTC (voice) once every minute (English even
minutes, French odd minutes).
BBC - British Broadcasting Corporation (United Kingdom). The BBC transmits on a number of
domestic and world-wide frequencies and transmits the Greenwich time signal (referenced to UTC)
once every hour on most frequencies, although there are some exceptions.
8.2.3 Further details of these and other acceptable time references can be found in AIS
documentation of the NAT ATS Provider States. In general, the use of any other source of UTC, that can be
shown to the State of the Operator or the State of Registry of the aircraft to be equivalent, may be allowed
for this purpose.
The Use of a Master Document
8.2.4 Navigation procedures must include the establishment of some form of master working
document to be used on the flight deck. This document may be based upon the flight plan, navigation log, or
other suitable document which lists sequentially the waypoints defining the route, the track and distance
between each waypoint, and other information relevant to navigation along the cleared track. When
mentioned subsequently in this guidance material, this document will be referred to as the 'Master
Document'.
8.2.5 Misuse of the Master Document can result in GNEs occurring and for this reason strict
procedures regarding its use should be established. These procedures should include the following:
a) Only one Master Document is to be used on the flight deck. However, this does not preclude
other crew members maintaining a separate flight log.
NORTH ATLANTIC MNPSA OPERATIONS MANUAL CHAPTER 8
NAT MNPS 43 Edition 2008
b) On INS equipped aircraft a waypoint numbering sequence should be established from the
outset of the flight and entered on the Master Document. The identical numbering sequence
should be used for storing waypoints in the navigation computers.
c) For aircraft equipped with FMS data bases, FMS generated or inserted waypoints should be
carefully compared to Master Document waypoints and cross checked by both pilots.
d) An appropriate symbology should be adopted to indicate the status of each waypoint listed
on the Master Document.
8.2.6 The following is a typical example of Master Document annotation. An individual
operator’s procedures may differ slightly but the same principles should be applied:
a) The waypoint number is entered against the relevant waypoint co-ordinates to indicate that
the waypoint has been inserted into the navigation computers.
b) The waypoint number is circled, to signify that insertion of the correct co-ordinates in the
navigation computers has been double-checked independently by another crew member.
c) The circled waypoint number is ticked, to signify that the relevant track and distance
information has been double-checked.
d) The circled waypoint number is crossed out, to signify that the aircraft has overflown the
waypoint concerned.
8.2.7 All navigational information appearing on the Master Document must be checked against the
best available prime source data. When a re-route is necessary, some regulators recommended that a new
Master Document is prepared for the changed portion of the flight. In cases where the original Master
Document is to be used, the old waypoints must be clearly crossed out and the new ones carefully entered in
their place. The checks listed in the previous paragraph must be carried out in respect of all new or revised
waypoints.
8.2.8 When ATC clearances or re-clearances are being obtained, headsets should be worn. The
inferior clarity of loud-speakers has, in the past, caused errors during receipt. Two qualified crew members
should monitor such clearances; one of them recording the clearance on the Master Document as it is
received, the other cross-checking the receipt and read-back. All waypoint co-ordinates should be read back
in detail, adhering strictly to standard ICAO phraseology, except where approved local procedures make this
unnecessary. Detailed procedures pertaining to abbreviated clearances/read-backs are contained in the
appropriate AIPs, and in this Manual at Chapter 5 - Oceanic ATC Clearances.
Position Plotting
8.2.9 A simple plotting chart provides a visual presentation of the intended route which, is defined
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
航空翻译14(38)
