No measuring of sleeves, bushings etc. is required.
Standard torque.values are applicable, unless otherwise specified as below.
2.
TORQUE VALUES
IPL FIG ITEM NOMENCLATURE TORQUE (Tol.: POUND.INCHES +/.10%) (NM)
Ref chapter 6 Repair Sec.6/Monitor replacing: step.5/a step.5/b 7 . 65 7 . 90 7 . 110 7A . 40 Hex. bolt Hex. bolt Screw, Rear Fitting Screw Nut Set Screw, front.stud 20.25 35 (max) 80 44 44 hand tighten only (max 44) 2.2 . 2.7 3.9 (max) ( 9) ( 5) ( 5) (max 5)
FITS AND CLEARANCES
TABLE 8001 (SHEET 1 OF 1)
Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE 654 SERIES
THIS PAGE INTENTIONALLY LEFT BLANK
Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE 654 SERIES
SPECIAL TOOLS, FIXTURES AND EQUIPMENT
1. TOOLS
A. M.Tool
(1) A maintenance tool as a hard. and software package (M.Tools Lie Flat Seat 6510) can be procured from Recaro: #148W00.100.00 The tool is authorized to accomplish functional tests, adjustments and fault isolation on seat assembly components as follows: actuators and pump, valve block, software, PCU, handset, pneumatic system
2. FIXTURES AND EQUIPMENT
Special fixtures or specific equipment are not required for maintenance or overhaul work to be carried out on the seat assemblies. However, using a tracking fixture to support the seat assy is recommended during the repair.
Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE 654 SERIES
THIS PAGE INTENTIONALLY LEFT BLANK
Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE 654 SERIES
ILLUSTRATED PARTS LIST
Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE 654 SERIES
INTRODUCTION
1.
GENERAL This Illustrated Parts List (IPL) contains the complete listing of all replaceable parts on the seat assy.
2.
MATERIAL ARRANGEMENT
A. INTRODUCTION
The introduction has all explanatory information for the individual sections as it is necessary for use of this IPL. The introduction further has a list of abbreviations used in the detailed parts list as well as a list of manufacturer codes, together with manufacturer names and addresses.
B. NUMERICAL INDEX
This section has a listing of part numbers of all items listed in the detailed parts list in alpha.numerical sequence with cross reference to respective Fig./Item Nos. including units per assy.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757−200 PASSENGER SEAT 乘客座椅(45)
