COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757−200 PASSENGER SEAT 乘客座椅(32)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

3 Grasp end bay deco panel from bottom to loosen hook and loop tape.
4 Gently slide the deco panel forward to disengage form arm rest cap trim.
5 Disconnect proximity lights, if necessary.

(d)  
REMOVE MONITOR SHROUD (Ref Fig 3001 sheet 2)

For removal the Monitor see TBD instructions. The following instructions are assuming that the
monitor is not installed.
1 Remove Deco Panel Forward with Eeagle. (Ref Step (b))
2 From aft side of seat, tilt top of monitor shroud aft and hold.
3 Remove 2 screws from side of monitor shroud.
4 Unhook montor shroud from video shroud frame assembly.

(e)  
REMOVE TABLE LATCH (Ref Fig 3001 sheet 2) 1 Remove Deco Panel Forward with Eagle. (Ref Step (b)) 2

 

If possible, lower table.
3

Remove 2 screws to remove table latch.
(f)  REMOVE COAT HOOK (Ref Fig 3001 sheet 2) 1
Pull coat hook lever aft.

Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE 654 SERIES
2 Remove 2 screws lcoated behind the lever to remove cat hook.

(g)  REMOVE TABLE INLAY ASSEMBLY (Ref Fig 3001 sheet 3) 1
Unhook table latch and lower table.
2

Gently peel up table inlay to disengage from double stick tape
(h)  
REMOVE TABLE T.BAR (Ref Fig 3001 sheet 3) 1 Unhook table latch and lower table. 2 Remove 2 screws to remove cover. 3 Remove 2 screws per T.bar.

(i)  
REMOVE LITERATURE POCKET TRIM ASSEMBLY (Ref Fig 3001 sheet 2) 1 Open Literature Pocket Doore. 2 Remove 5 screws and 5 wshers to remove literature pocet trim assembly.

(j)  
REMOVE LITERATURE DOOR (Ref Fig 3001 sheet 2/4) 1 Open Literature Door. 2 Disengage deco literature closeout panel to access fasteners, if necessary. 3 Remove 4 screws from hinge to remove literature pocket door.

(k)  
REMOVE LITERATUR DOOR lATCH (Ref Fig 3001 sheet 4) 1 Open Literature Door. 2 Remove 4 screws to remove cover. 3 Remove 2 screws to remove latch support bracket. 4 Remove 4 screws to unfasten 2 outer latch components and latch mount blocks. 5 Slide outer latch components away from rods. 6

(l)  
REMOVE ARM ASSEMBLY (Ref Fig 3001 sheet 5; 6)

 

Slide rods away from center latch components.
7

Rotate and slide center latch component out of the door panel.

Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE 
654 SERIES 
1  Remove outboard end bay deco panel. (Ref Step (c)) 
2  Remove 2 retaining rings to remove gas spring. 
3  Remove 1 bolt from aft section of arm assembly 
4  Pull up on latch lever to realese latch. 
5  Pull arm assembly up through hole in end bay arm rest trim. 
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757−200 PASSENGER SEAT 乘客座椅(32)