标准施工手册 STANDARD PRACTICES MANUAL 20-00-02/70-00-01(17)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

Abbreviations used throughout the manual are explained in Table 1. Table 1. Abbreviations and Definitions
Abbreviation Definitions
ac Alternating current AISI American Iron and Steel Institute amp Ampere(s) AMS Aerospace Material Specification ASTM American Society for Testing and Materials ATA Air Transport Association AWS American Welding Society C Celsius or Centigrade dc Direct current Dia Diameter Dim. Dimension F Fahrenheit FAA Federal Aviation Administration ID Inside Diameter in. Inch lb-in. Pound-Inch kPa Kilopascal L Liter MAX. Maximum MIN Minimum ml Mililiter mm Milimeter No. Number OD Outside Diameter oz-in. Ounce-Inch REF Reference rpm Revolutions per minute SAE Society of Automotive Engineers v Volt
Introduction
Page 2 Apr 1/05 Copying, use or disclosure of information on this page is subject to proprietary restrictions.
20-00-02/70-00-01
SECTION I – DISASSEMBLY
TABLE OF CONTENTS
SECTION PAGE
1. Standard Disassembly Practices ................................................................................................. 101

A. General..................................................................................................................................101

B. Identification of Matched Parts and Sets............................................................................... 101

C. Handling Component Parts ................................................................................................... 101

D. Disassembly Area.................................................................................................................. 101

E. General Procedures .............................................................................................................. 101

F. Disassemble Bearings........................................................................................................... 102

Disassembly Page TC-1 Apr 1/05
20-00-02/70-00-01

PAGE INTENTIONALLY LEFT BLANK

Disassembly
Page TC-2 Apr 1/05 Copying, use or disclosure of information on this page is subject to proprietary restrictions.
20-00-02/70-00-01
SECTION I – DISASSEMBLY
1.  Standard Disassembly Practices
A.  General
This section of the manual provides general information that is applicable to the disassembly of any unit. Specific instructions for a particular unit shall be obtained from the applicable manual for the unit.
B.  Identification of Matched Parts and Sets
(1)
Refer to applicable parts list for the unit being disassembled prior to starting disassembly procedures.

(2)
List items that are specified as matched parts or sets.

(3)
During disassembly, identify and tag the matched items for processing through cleaning, inspection, etc. Do not co-mingle matched items with other like items.

C.  Handling Component Parts
CAUTION: EXERCISE CARE IN HANDLING COMPONENTS TO PREVENT DAMAGE TO SERVICEABLE PARTS THROUGH ROUGH HANDLING.
Perform the following steps for component parts that are removed from the basic unit, but do not require disassembly.
(1)
Tag components for identification and processing.

(2)
Clean components in accordance with SECTION II.

(3)
Perform visual inspection of components in accordance with SECTION III.

(4)  
Cap, plug, or seal ports and orifices.  Place components in a clean plastic bag or equivalent container for protection from contaminants.

D.  Disassembly Area
Disassembly shall be accomplished in a clean, dry, dust-free, well lighted area.  Workbenches shall be clean and covered with paper or other protective material.
E.  General Procedures
(1)  
Place parts on workbench in the order of disassembly in preparation for cleaning and inspection. Keep hardware and small parts together in trays or baskets.
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：标准施工手册 STANDARD PRACTICES MANUAL 20-00-02/70-00-01(17)