20-00-02/70-00-01
CAUTION: COTTER KEY WASHERS ARE NOT REUSABLE. INSTALL NEW KEY WASHER AS SPECIFIED IN APPLICABLE MANUAL FOR UNIT IN WORK.
B. Cotter Key Installation
(1) Install new key washers to retain nuts as shown in Figure 510.
NOTE: Methods 1, 2, and 3 are typical examples.
Typical Installation of Key Washers
Figure 510
Assembly
Page 531
Apr 1/05
20-00-02/70-00-01
8. Marman Clamps
A. Marman Clamp (Coupling) Installation
(1)
Position clamp over mating component flanges as described in applicable manual.
(2)
Engage bracket of clamp and tighten nut of attaching bolt to torque specified in applicable manual.
(3)
Using a rawhide mallet (SECTION VII), tap around outside diameter of clamp to ensure that clamp is properly seated.
(4)
Retighten nut on attaching bolt of clamp to torque specified in applicable manual.
Assembly
Page 532 Apr 1/05 Copying, use or disclosure of information on this page is subject to proprietary restrictions.
20-00-02/70-00-01
SECTION VI – PACKAGING
TABLE OF CONTENTS
SECTION PAGE
1.
General ................................................................................................................................... 601
2.
Bearing Preservation, Handling, and Storage ............................................................................. 601
Packaging
Page TC-1 Apr 1/05 Copying, use or disclosure of information on this page is subject to proprietary restrictions.
20-00-02/70-00-01
PAGE INTENTIONALLY LEFT BLANK
Packaging
Page TC-2 Apr 1/05 Copying, use or disclosure of information on this page is subject to proprietary restrictions.
20-00-02/70-00-01
SECTION VI – PACKAGING
1.
General Refer to applicable manual for unit in work for general packaging procedures.
2.
Bearing Preservation, Handling, and Storage
.
Coat bearings with preservative oil (MIL-L-6085) (SECTION VII).
.
Individually seal bearings in plastic bags (SECTION VII).
.
Store in a dry area cooled by refrigeration. Do not store in areas cooled by evaporative coolers.
.
Do not store bearings near electrical motors or transport in electrically operated trucks to preclude possibility of magnetizing.
Packaging Page 601/602 Apr 1/05
20-00-02/70-00-01
SECTION VII – APPENDIX
TABLE OF CONTENTS
SECTION PAGE
1.
General ........................................................................................................................................ 701
2.
Conversion Tables and Charts (Measurement and Drill Bit Sizes) ............................................. 701
3.
Temperature Conversion ............................................................................................................. 701
A. Examples 1: Fahrenheit to Centigrade/Celsius Conversion ................................................ 701
B. Examples 2: Centigrade/Celsius Conversion to Fahrenheit ................................................ 702
4.
Equipment List ............................................................................................................................. 725
5.
Consumables List ........................................................................................................................ 727
6.
Specification List .......................................................................................................................... 734
TABLE PAGE 中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：标准施工手册 STANDARD PRACTICES MANUAL 20-00-02/70-00-01(117)
