A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵2(29)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

R  to 0.5 m.daN (44.24 lbf.in). 
R  (f) Make sure that the adjustment is correct after you have tightened 
R  the nuts. 
R  (g) Safety the nuts with lockwire corrosion resistant steel dia 0.8 
R  mm (0.03 in.) 
R  (23) Install the washer (10), install and tighten the nut (12). Safety it 
R  with the new cotter pin (11). 
R  (24) Install the rod (17) and the bolt (21). If necessary, adjust the 
R  length of the rod (17) as follows: 
R  (a) Cut and discard the lockwire. 
R  (b) Loosen the nuts (13) and (16) and disengage the lockwashers (14) 
R  and (15). 

R 1EFF : 301-399, 1 27-21-44Page 417 1 1 May 01/04 1 1 1CES 1

R R  (c) Adjust the length of the rod (17) until you can install the bolt (21). 
R R R  (d) Engage the lockwashers (14) and (15) and TORQUE the nuts (13) and (16) to 1.374 m.daN (10.13 lbf.ft). Safety them with Lockwire corrosion resistant steel dia 0.8 mm (0.03 in.). 
R R  (25) Install the washer (22), install and tighten the nut (23). Safety it with the new cotter pin (24). 
R R  (26) Remove the PIN, RIGGING - RUDDER CONTROL (98A27901002000) (35) from the yaw/brake bellcranks of the CAPT and F/O. 
R  **ON A/C ALL
 Subtask 27-21-44-080-050
 B. Remove the PIN, RIGGING - RUDDER CONTROL (98A27901002000) (36) from the tension regulator.
 Subtask 27-21-44-710-050
 C. Test of the CAPT Yaw/Brake Bellcrank
 (1) Do the operational test of the rudder mechanical control (Ref. TASK 27-24-00-710-001).
 (2) Do the operational test of the normal braking system (operational check of the pedals) (Ref. TASK 32-42-00-710-001).
 (3) Do the operational test of the alternate braking system (operational check of the pedals) (Ref. TASK 32-43-00-710-001).
 5. Close-up________
 Subtask 27-21-44-942-050
 A. Put the aircraft back to the serviceable condition.
 (1) Make sure that the work area is clean and clear of tool(s) and other items.
 (2) Remove the warning notice(s).

 

 Subtask 27-21-44-410-050
 B. Close Access
 (1)
 Close the access door 811.

 (2)
 Remove the access platform(s).

 1EFF : ALL 1 27-21-44Page 419 1 1 May 01/04R 1 1 1CES 1

 TASK 27-21-44-000-002
 Removal of the F/O Yaw/Brake Bellcrank
 1.
 Reason for the Job

__________________
 Self Explanatory

 2.
 Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
 -------------------------------------------------------------------------------
No specific warning notice
 No specific access platform 1.5 m (4 ft. 11 in.)
 98A27901002000 1 PIN, RIGGING - RUDDER CONTROL

 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------

R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
 27-21-44-991-001 Fig. 401
 **ON A/C 301-399,
 27-21-44-991-001-A Fig. 401A
 **ON A/C ALL
 27-21-44-991-004 Fig. 404
 27-21-44-991-005 Fig. 405

 

 3. Job Set-up
__________
 Subtask 27-21-44-941-053

 A. Put the warning notice
 (1) Put a warning notice to tell persons not to pressurize the Green and the Yellow hydraulic systems.
 (2) Put a warning notice to tell persons not to operate the pedals. Subtask 27-21-44-010-051
 B. Get Access
 (1)
 Put the access platform in position.

 (2)
 Open the access door 811.

 4. Procedure
_________ R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
 (Ref. Fig. 401/TASK 27-21-44-991-001)
 **ON A/C 301-399,

 (Ref. Fig. 401A/TASK 27-21-44-991-001-A)
 **ON A/C ALL

 (Ref. Fig. 404/TASK 27-21-44-991-004, 405/TASK 27-21-44-991-005)
 Subtask 27-21-44-480-051

 A. Install the PIN, RIGGING - RUDDER CONTROL (98A27901002000) (36) on the tension regulator.

 F/O Yaw/Brake Bellcrank Figure 404/TASK 27-21-44-991-004
 1EFF : 1 1R 1CES  ALL  1 11 1 27-21-44 Page 422 May 01/04

 

 F/O Yaw/Brake Bellcrank
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵2(29)