(2)
In the cabin, on each emergency oxygen container, pull the door stops and turn them 90 degrees to the test position.
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 23-32-00Page 506 1201-299, 301-399, 1Aug 01/05 1 1 1CES 1R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
4. Procedure
_________ R **ON A/C 001-049, 051-099, 101-105, 151-199, 201-299,
Subtask 23-32-00-710-050-A
A. Test of the Prerecorded Announcement Operation NOTE : The subsequent procedure is a general test. The prerecorded
____ announcements are normally established by the operator in accordance with the PRAM-Vendor. Therefore the prerecorded announcement numbers may be different.
NOTE : You can check the announcement only if they are recorded.
____
(1) Do this test.
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the circuit breaker panel 2000VU:
-close the circuit breaker PRAM (2RX).
2. On the FAP 120RH, prerecorded announcement section:
-set the announcement 1 to MEMO 1 and push the ENTER pushbutton switch.
3. On the FAP 120RH, prerecorded announcement section:
-set the announcement 2 to MEMO 2 and push the ENTER pushbutton switch.
4. On the FAP 120RH, prerecorded announcement section: On the Forward Attendant Panel (FAP)120RH, prerecorded announcementsection:
-all displays show '0'.
-
the cursor is in the MEMO 1 position.
On the FAP 120RH, prerecordedannouncement section:
-
the MEMO 1 display shows '1'.
-
the cursor moves to the MEMO 2position.
-after some seconds the READY light comes on.
On the FAP 120RH, prerecordedannouncement section:
-
the MEMO 2 display shows '2'.
-
the cursor moves to the MEMO 3position.
On the FAP 120RH, prerecordedannouncement section:
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 23-32-00Page 507 1201-299, 301-399, 1Aug 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
- set the announcement 3 to MEMO 3 and push the ENTER pushbutton switch. - the MEMO 3 display shows '3'.- the cursor moves to the MEMO 1position.
5. On the FAP 120RH, prerecorded announcement section: On the FAP 120RH, prerecordedannouncement section:
- push the START NEXT pushbutton switch. - the number shown on the MEMO 1display moves to the ON ANNOUNCE display. - the number shown on the MEMO 2
display moves to the MEMO 1 display. - the number shown on the MEMO 3
display moves to the MEMO 2 display. - the MEMO 3 display shows '0'.
In the cabin and the lavatories:
- you can hear the announcement 1 from the loudspeakers.
NOTE : After an announcement has finished the ON ANNOUNCE display shows '0'.
____
6. On the FAP 120RH, prerecorded announcement section:
-push the START ALL pushbutton switch.
7. On the FAP 120RH, prerecorded announcement section:
-set the announcement 1 to MEMO 1 and push the ENTER pushbutton switch.
8. On the FAP 120RH, prerecorded announcement section:
-push the START NEXT pushbutton switch and before the announcement has finished push the STOP pushbutton switch.
In the cabin and the lavatories:
-you can hear the announcements 2 and3 from the loudspeakers in sequence.
On the FAP 120RH, prerecorded announcement section:
-
the READY light goes off.
On the FAP 120RH, prerecordedannouncement section:
-
the MEMO 1 display shows '1'.
-after some seconds the READY lightcomes on.
On the FAP 120RH, prerecordedannouncement section:
-the number shown on the MEMO 1display moves to the ON ANNOUNCEdisplay.
In the cabin and the lavatories:
R 1EFF : 001-049, 051-099, 101-105, 151-199, 1 23-32-00Page 508 1201-299, 1Aug 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
9. On the FAP 120RH, prerecorded announcement section:
-set the announcement 350 to MEMO 1.
10. On the FAP 120RH, prerecorded announcement section:
-push the ENTER pushbutton switch.
11. On the FAP 120RH, prerecorded announcement section:
-set the announcement 1 to MEMO 1 and push the CLEAR pushbutton.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM Communications 通讯1(156)
