• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-02-24 09:22来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 (b)
 Turn the COCKPIT, the FWD CABIN and the AFT CABIN temperature selectors to the HOT position.

 

 (4)
 Move the applicable throttle control lever forward until on the upper ECAM DU a N2 of 95% is shown.

 (5)
 Keep this condition for 15 minutes. NOTE : During this 15 minute period you must constantly monitor the

____
 pack temperatures.


 (6)
 To do this you must:

 (a)
 On the ECAM control panel push the BLEED pushbutton switch.

 (b)
 On the ECAM lower DU make sure that:

 -
the pack compressor outlet temperature does not go above 230 deg. C maximum (max.) and

 -
the pack outlet temperature does not go above 85 deg. C (max.). NOTE : If any of the temperatures go above max. you must stop the

 

 


____ procedure and do the trouble shooting of the ECS (refer to TSM, chapter 21).
 (7)
 Move the applicable throttle control lever to the idle position.

 (8)
 On the ECAM control panel push the COND pushbutton switch.


R 1EFF : 001-003, 051-054, 1 21-00-00Page 281 1 1 Aug 01/05 1 1 1CES 1


 (9) Blow warm air onto the zone temperature sensor 21HK (behind the grill in the cockpit ceiling) with a warm air blower.
 NOTE : Do not damage the cockpit interior with to much heat from the
____
 warm air blower.

 (10) On the ECAM lower DU monitor the CKPT compartment temperature until it shows between 30 and 40 deg. C.
 NOTE : You must keep this condition during work steps (10) to (12) by
____
 use of the warm air blower as in work step (8).

 (11)
 On the AIR COND panel 30VU turn the COCKPIT, the FWD CABIN and the AFT CABIN temperature selectors to the COLD position.

 (12)
 Move the applicable throttle control lever forward until on the upper ECAM DU a N2 of 95% is shown.

 (13)
 Keep this condition for 15 minutes. NOTE : During this 15 minute period you must also constantly monitor

____ the pack temperatures as in work step (5) of this paragraph.

 (14)
 Move the applicable throttle control lever to the idle position.

 (15)
 Stop the warm air blower.

 (16)
 On the ECAM control panel push the COND pushbutton switch.

 (17)
 On the ECAM lower DU make sure that the CKPT, the FWD cabin and the AFT cabin temperatures decrease to, or are less than 24 deg. C.

 (18)
 On the AIR COND panel 30VU turn the COCKPIT, the FWD CABIN and the AFT CABIN temperature selectors to the HOT position.

 (19)
 Move the applicable throttle control lever forward until on the upper ECAM DU a N2 of 95% is shown.

 (20)
 Keep this condition for 15 minutes. NOTE : During this 15 minute period you must constantly monitor the


____ pack temperatures as in work step (5) of this paragraph.
R 1EFF : 001-003, 051-054, 1 21-00-00Page 282 1 1 Aug 01/05 1 1 1CES 1R **ON A/C 004-049, 055-099, 101-149, 151-199, 201-299, 301-399, 401-499,

 

 Subtask 21-00-00-160-057-A
 J. Stage 1 Cleaning of the ECS WARNING : BE CAREFUL WHEN YOU DO THIS CLEANING PROCEDURE. A VERY STRONG
_______ HOT OR COLD AIRFLOW WILL OCCUR IN THE AREA OF THE PACK BAY. THIS AIRFLOW CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE TO EQUIPMENT.
 WARNING : MAKE SURE THAT THERE ARE NO PERSONS OR EQUIPMENT NEAR THE RAM
_______ AIR OUTLETS. HOT EXHAUST GASES CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE TO EQUIPMENT.
 CAUTION : MAKE SURE THAT THE AREA NEAR THE RAM AIR INLET IS CLEAN AND
_______ FREE FROM LOOSE ARTICLES. LOOSE ARTICLES CAN GO INTO THE RAM AIR INLET AND CAUSE DAMAGE TO EQUIPMENT.
 NOTE : Make sure that at least one of the windows in the cockpit stays
____ open during this part of the decontamination procedure.
 (1)
 Start the engine 1(2) (Ref. TASK 71-00-00-710-003).

 (2)
 On the AIR COND panel 30VU:

 (a) Make sure that:
 -
the X BLEED selector is at the AUTO position,

 -
the PACK 1 and the PACK 2 pushbutton switches are in the on position (the FAULT and the OFF legends are off).

 

 (3)
 After 3 minutes:

 (a)
 On the CARGO HEAT panel 22VU and the AIR COND panel 30VU push the HOT AIR pushbutton switches to the off position (the OFF legends come on).

 (b)
 Turn the COCKPIT, the FWD CABIN and the AFT CABIN temperature selectors to the HOT position.

 

 (4)
 Move the applicable throttle control lever forward until on the upper ECAM DU a N2 of 95% is shown.
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM AIR CONDITIONING 空调 1(86)