On the FWD cargo door:
-
the cargo door must stay in the sameposition.
On the FWD cargo door:
-
the target lever of the switchmechanism moves outboards,
-
the target of the control lever is in line with the proximity sensor.
-
the latching hooks move to the unlocked position,
On the FWD cargo door:
-
the cargo door moves in the closedirection.
-when the cargo door is fully closed, the interlock mechanism does not block the latching shaft.
On the FWD cargo door:
R 1EFF : 062-099, 106-149, 151-199, 204-299, 1 52-31-00Page 512 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
- examine the cargo door during - the cargo door must close smoothly
the movement. and easily.
10. On the control panel: On the FWD cargo door:
- release the selector when the - the cargo door stays in the closed
cargo door is fully closed. position.
11. On the FWD cargo door: On the FWD cargo door:
- move the door handle down to - the latching hooks engage with the
the LOCKED position. latch fittings,
- the cargo door is in the fully closed
position,
- the vent door closes,
- the drift pins extend in the pockets
of the fuselage,
- the latching handle is in line with
the outer skin and locked.
On the lower ECAM DU:
- the message CARGO goes off and the
symbol for the FWD cargo door changes
to green.
On the FWD cargo door: On the FWD cargo door:
- make sure that the cargo door - you can see the green mark on each
is correctly latched and safety cam through the indication
locked window.
- make sure that the vent door - the vent door seal touches the inner
is correctly closed. surface of the outer skin.
- examine the cargo door seal of - the door seal is compressed around
the closed cargo door. its length.
R 1EFF : 062-099, 106-149, 151-199, 204-299, 1 52-31-00Page 513 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1 **ON A/C ALL
5. Close-up
________ Subtask 52-31-00-860-052
A. Put the aircraft back to the serviceable condition.
(1)
Do the EIS stop procedure
(Ref. TASK 31-60-00-860-002)
(2)
Make sure that the Yellow auxiliary hydraulic system is depressurized (Ref. TASK 29-24-00-864-001).
(3)
Make sure that the aircraft electrical circuits are de-energized (Ref. TASK 24-41-00-862-002).
Subtask 52-31-00-410-052
B. Close Access
(1)
Close the access panel 134AR.
(2)
Install the access panel 825AR.
(3)
Remove the access platform(s).
1EFF : ALL 1 52-31-00Page 514 1 1 May 01/05R 1 1 1CES 1
TASK 52-31-00-720-001
Functional Test of the FWD Cargo-Compartment Door
1. Reason for the Job
__________________
Refer to the MPD TASK: 523100-01
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
R No specific access platform 2.0 m (6 ft. 7 in.) R No specific 1 SPRING BALANCE 20 DAN (48 LBF) 98D52307525000 1 ADJUSTMENT TOOL - CARGO DOORS
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power 29-14-00-614-002 Pressurization of the Hydraulic Reservoirs through
the Ground Connector 29-24-00-864-001 Depressurize the Yellow Hydraulic System 52-30-00-860-001 Open the FWD or AFT Cargo-Compartment Door with the
Yellow Electric Pump 52-30-00-860-002 Close the FWD or AFT Cargo-Compartment Door with the
Yellow Electric Pump 52-31-11-820-001 Adjustment of the FWD Cargo-Compartment Door 52-31-11-820-002 Adjustment of the Door Mechanism 52-31-13-000-001 Removal of the Lining and the Insulation 52-31-13-400-001 Installation of the Lining and the Insulation 52-31-21-000-002 Removal of the Handle Flap Mechanism 52-31-21-400-002 Installation of the Handle Flap Mechanism 52-35-13-400-002 Installation of the Proximity Switches 5MJ and 12MJ 52-71-12-400-001 Installation of the Proximity Switches 28WV and 34WV 52-71-12-400-002 Installation of the Proximity Switches 30WV and 32WV
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM DOORS 舱门4(35)
