MCDU System Displays - SFCC Test
Figure 004 (SHEET 1)
1EFF : ALL 1 27-80-00 Page 8
1 1 Feb 01/98
1 1
1CES 1
MCDU System Displays - SFCC Test
Figure 004 (SHEET 2)
1EFF : ALL 1 27-80-00 Page 9
1 1 Feb 01/98
1 1
1CES 1
MCDU System Displays - SFCC Test
Figure 004 (SHEET 3)
1EFF : ALL 1 27-80-00 Page 10
1 1 Feb 01/98
1 1
1CES 1
INTENTIONALLY BLANK
1 1
27-80-00Page 11
1 1 Feb 01/98 1 1 1CES 1
MCDU System Displays - WTB/POB Test
Figure 005 (SHEET 1)
1EFF : ALL 1 27-80-00 Page 12
1 1 Feb 01/98
1 1
1CES 1
MCDU System Displays - WTB/POB Test
Figure 005 (SHEET 2)
1EFF : ALL 1 27-80-00 Page 13
1 1 Feb 01/98
1 1
1CES 1
LIFT AUGMENTING (SLATS) - MAINTENANCE PRACTICES
_______________________________________________
TASK 27-80-00-866-004
Extending the Slats on the Ground
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
GEAR.
R
1. Reason for the Job
__________________
To extend the slats without movement of the flaps. To extend the slats and flaps at the same time (Ref. TASK 27-50-00-866-00801).
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
No specific safety barriers
No specific warning notice(s)
98D27803000000 1 LOCKING TOOL - FLAP/SLAT CONTROL LEVER
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power 27-00-00-480-002 Installation of the Flap/Slat Control-Lever Locking Tool (98D27803000000) 29-10-00-863-003 Pressurize the Blue Hydraulic System with a Ground
Power Supply 29-10-00-864-003 Depressurize the Blue Hydraulic System 31-60-00-860-001 EIS Start Procedure
3. Job Set-Up
__________ Subtask 27-80-00-941-052
A. Safety Precautions
(1)
Put the safety barriers in position.
(2)
Put the warning notice(s) in position to tell persons that the slat system is in operation.
Subtask 27-80-00-860-052
B. Aircraft Maintenance Configuration
(1)
Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
(2)
Pressurize the Blue hydraulic system
(Ref. TASK 29-10-00-863-003).
NOTE : The Blue and/or Green hydraulic system(s) operate(s) the slat
____ system. If necessary, use the alternative hydraulic system.
NOTE : If you use the Blue Hydraulic System, an ECAM S/CTL SLAT SYS 2
____ FAULT message will show. This message can be ignored.
NOTE : If you use the Green Hydraulic System, an ECAM S/CTL SLAT SYS
____ 1 FAULT message will show. This message can be ignored.
1EFF : ALL 1 27-80-00Page 202 1 1 Nov 01/02R 1 1 1CES 1
(3) Set the ECAM system to on (Ref. TASK 31-60-00-860-001).
Subtask 27-80-00-865-054
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 49VU AUTO FLT/FAC1/26VAC 14CC1 B03 121VU AUTO FLT/FAC2/26VAC 14CC2 M18 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵7(35)
