• 热门标签

当前位置: 主页 > 航空资料 > 飞行资料 >

时间:2011-03-14 17:01来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

Verify that the PASS OXY ON light is extinguished. Landing gear indicator lights .................................Verify illuminated Manual gear extension access door ......................................... Closed
Accomplish the CDU Preflight Procedure, Preflight Procedure - First Officer and Preflight Procedure - Captain to ensure that the flight deck preparation procedure is complete.
BEFORE TAXI checklist.................................................Accomplish
IRS alignment ......................................................................Complete

Starting with Ground Air Source (AC electrical power available)
Engine No. 1 must be started first.
When cleared to start: APU BLEED air switch...............................................................OFF Engine No. 1 start ............................................................Accomplish
Use normal start procedures.
WARNING:To minimize the hazard to ground personnel, the external air should be disconnected, and engine No. 2 started using the Engine Crossbleed Start procedure.
Engine Crossbleed Start
Prior to using this procedure, ensure that the area to the rear is clear. Engine BLEED air switches............................................................... ON APU BLEED air switch ....................................................................OFF PACK switches..................................................................................OFF
Copyright . The Boeing Company. See title page for details.

Supplementary Procedures -Engines, APU
737 Flight Crew Operations Manual
ISOLATION VALVE switch .........................................................AUTO Ensures bleed air supply for engine start.
Engine thrust lever (operating engine) ................................ Advance thrust lever until bleed duct pressure indicates 30 PSI
Non–operating engine.......................................................................Start Use normal start procedures with crossbleed air.
 After starter cutout, adjust thrust on both engines, as required.
Setting N1 Bugs with an Inoperative FMC
Reference the Performance – Inflight section to determine N1 setting for desired phase of flight.
N1 SET outer knob ........................................................................BOTH The last FMC computed value is displayed by reference N1 bugs and readouts. If the FMC has not calculated an input since power up, a default value of 104% is displayed.
N1 SET inner knob ........................................................................Set N1

Note: If the N1 SET outer knob is returned to the AUTO position, the bugs and readouts will revert to the last FMC computed value or 104% if the FMC has not calculated an input since power up.
Copyright . The Boeing Company. See title page for details.
Supplementary Procedures -Engines, APU 737 Flight Crew Operations Manual

Intentionally
Blank

Copyright . The Boeing Company. See title page for details.
SP.7.6  July 28, 2000

737 Flight Crew Operations Manual

Fire and Overheat System Test with an Inoperative Loop
To determine the specific inoperative loop:
OVHT DET switches .......................................................................A

Test switch ......................................................................OVHT/FIRE If the FAULT light remains extinguished and both ENG
OVERHEAT lights and engine fire warning switches illuminate,
loop A is good.
If the FAULT light illuminates and one of the ENG OVERHEAT

lights and corresponding engine fire warning switch remain
extinguished, there is a fault in loop A of the detection system of
that engine.

OVHT DET switches .......................................................................B

Test switch ......................................................................OVHT/FIRE If the FAULT light remains extinguished and both ENG
OVERHEAT lights and engine fire warning switches illuminate,
loop B is good.
If the FAULT light illuminates and one of the ENG OVERHEAT

lights and corresponding engine fire warning switch remain
extinguished, there is a fault in loop B of the detection system of
that engine.

OVHT DET switches .......................................................As required Select the good loop for each engine (NORMAL if both loops tested good).
Test switch ......................................................................OVHT/FIRE If the test is successful leave the fire panel in this configuration for flight.
Copyright . The Boeing Company. See title page for details.
Supplementary Procedures -Fire Protection 737 Flight Crew Operations Manual

Intentionally
Blank

Copyright . The Boeing Company. See title page for details.
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:737NG机组操作手册Flight Crew Operations Manual FCOM 1(79)