- swap back the CPC 1 (11HL) and the CPC 2 (12HL) (Ref. AMM TASK 21-31-34-000-001) and (Ref. AMM TASK 21-31-34-400-001).
- replace the CONTROLLER-CABIN PRESSURE 2 (12HL) (Ref. AMM TASK 21-31-34-000-001) and (Ref. AMM TASK 21-31-34-400-001).
(2) If the fault does not move with the CPC 2:
- swap back the CPC 1 (11HL) and the CPC 2 (12HL) (Ref. AMM TASK 21-31-34-000-001) and (Ref. AMM TASK 21-31-34-400-001).
- do the operational test of the AFS (Ref. AMM TASK 22-96-00-710-
001). R
R (a) If the test gives a different maintenance message, refer to the R Fault Symptom List.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞21-31-00∞∞∞∞∞∞∞∞∞∞Page 234
Feb 01/05 CES (b) If the fault continues:
- do a check and repair the wiring of the signal ARINC 429 OUT from the FMGC 2 (1CA2) to the CPC 2 (12HL) (Ref. ASM 21-31/03).
R C. Do the test as given in the Para. 3.A.
5. Close-up
________
A. Put the aircraft back to its initial configuration.
TASK 21-31-00-810-814
CPC 1 receives no Data from the ADIRS
1. Possible Causes
_______________
- CONTROLLER-CABIN PRESSURE 1 (11HL)
- wiring
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 21-31-00-710-002 Operational Test of the Pressure Control and
Monitoring AMM 21-31-34-000-001 Removal of the Cabin Pressure Controller (11HL,12HL) AMM 21-31-34-400-001 Installation of the Cabin Pressure Controller
(11HL,12HL) AMM 34-13-00-740-002 INTERFACE TEST of the ADR ASM 21-31/03
3. Fault Confirmation
__________________
A. Test
(1) Do a read-out of the CLASS III FAULT REPORT of the cabin
pressure-control system 1.
NOTE : If a fault is detected, the CLASS III FAULT REPORT of the CPC
____ shows a fault code for shop maintenance in addition to the related CFDS message(s). For detailed information see the applicable Page Block 301.
(2) Make sure that all ADIRS (1,2 and 3) are switched on.
(3) Do the operational test of the pressure control and monitoring system (Ref. AMM TASK 21-31-00-710-002).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞21-31-00∞∞∞∞∞∞∞∞∞∞Page 236
Aug 01/03R
CES
4. Fault Isolation
_______________
A. If the test with the CPC 1 (11HL) gives the maintenance message NO DATA FROM ADIRS 1 (19):
- swap the CPC 1 (11HL) and the CPC 2 (12HL) (Ref. AMM TASK 21-31-34-000-001) and (Ref. AMM TASK 21-31-34-400-001).
(1) If the fault moves with the CPC 1:
- swap back the CPC 1 (11HL) and the CPC 2 (12HL) (Ref. AMM TASK 21-31-34-000-001) and (Ref. AMM TASK 21-31-34-400-001).
- replace the CONTROLLER-CABIN PRESSURE 1 (11HL) (Ref. AMM TASK 21-31-34-000-001) and (Ref. AMM TASK 21-31-34-400-001).
(2) If the fault does not move with the CPC 1:
- swap back the CPC 1 (11HL) and the CPC 2 (12HL) (Ref. AMM TASK 21-31-34-000-001) and (Ref. AMM TASK 21-31-34-400-001).
- do the INTERFACE test of the ADR system (Ref. AMM TASK 34-13-00-
740-002). R
R (a) If the test gives a different maintenance message refer to the R Fault Symptom List.
(b) If the fault continues:
- do a check and repair the wiring of the signal DATA BUS #3 from the ADIRS 1 (1FP1) to the CPC 1 (11HL) (Ref. ASM 21-31/03).
B. If the test with the CPC 1 (11HL) gives the maintenance message NO DATA FROM ADIRS 2 (20):
- swap the CPC 1 (11HL) and the CPC 2 (12HL) (Ref. AMM TASK 21-31-34-000-001) and (Ref. AMM TASK 21-31-34-400-001).
(1) If the fault moves with the CPC 1:
- swap back the CPC 1 (11HL) and the CPC 2 (12HL) (Ref. AMM TASK 21-31-34-000-001) and (Ref. AMM TASK 21-31-34-400-001).
中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：A320 Trouble Shooting Manual 排故手册 AIR CONDITIONING 空调1(102)
