(g)
80000-03-01010203 Loader - Data, Portable, ARINC 615/A with Mass Storage Device (alternative) Demo Systems, Inc. (Vendor Code 0BAW0) 379 Science Dr., MoorPark, CA 93021
(h)
964-0400-024 Loader - Data, Portable, ARINC 615, 3.5 Inch Diskette (alternative) Honeywell, Inc. (Vendor Code 97896) 15001 N.E. 36th St., P.O. Box 97001, Redmond WA 98073-9701
(i)
964-0400-025 Loader - Data, Portable, ARINC 615, 3.5 Inch Diskette (alternative) Honeywell, Inc. (Vendor Code 97896) 15001 N.E. 36th St., P.O. Box 97001, Redmond WA 98073-9701
(j)
YV68A110 Loader - Data, Portable, ARINC 615 (alternative) SFIM (Vendor Code F6158) SA 13 AV Marcel Ramofo Garmier, Massy, 91301 France
D. Access
(1) Location Zone
212 Flight Compartment - Right
ú
31-31-03
ALL ú ú 08 Page 208 ú Sep 28/01
A
757 MAINTENANCE MANUAL
E. Procedure
S 862-010
(1)
Do this task: Supply Electrical Power (AMM 24-22-00/201).
S 412-011
(2)
Do these steps to prepare for the software installation:
(a)
Make sure you know the correct software part number for the FDAU. For the FDAU to be an approved installation, the correct software part number must be installed.
(b)
Make sure the system select switch on the data loader control panel (P61) is set to NORM or NORMAL.
CAUTION: MAKE SURE THE DATA LOADER CIRCUIT BREAKER IS OPEN BEFORE
_______ YOU CONNECT OR REMOVE THE DATA LOADER CABLE. IF THE CIRCUIT BREAKER IS NOT OPEN, DAMAGE TO EQUIPMENT CAN OCCUR.
(c) Open this circuit breaker and attach a DO-NOT-CLOSE tag:
1) Circuit Breaker Panel, P11 or P37: a) 11F23, DATA LOADER
CAUTION: MAKE SURE THE POWER SWITCH FOR THE PORTABLE DATA LOADER IS
_______ SET TO OFF BEFORE YOU CONNECT OR REMOVE THE INTERFACE CABLE. IF THE POWER SWITCH IS NOT OFF, DAMAGE TO THE PORTABLE DATA LOADER CAN OCCUR.
(d)
Connect the interface cable of the portable data loader to the DATA TRANSFER UNIT RECEPTACLE on the P61 panel.
(e)
Remove the DO-NOT-CLOSE tag and close this circuit breaker:
(f)
Circuit Breaker Panel, P11 or P37:
1) 11F23, DATA LOADER
(g)
AIRPLANES WITH ONE SWITCH ON THE DATA LOADER CONTROL PANEL (P61); Set the system select switch on the data loader control panel to the applicable position. 1) DFDAU position to install the mandatory FDAU software. 2) ACMS position to install non-mandatory FDAU software.
(h)
AIRPLANES WITH TWO SWITCHES ON THE DATA LOADER CONTROL PANEL (P61); Do these steps at the data loader control panel: 1) Set the upper switch to SINGLE SYS. 2) Set the system select switch to the applicable position:
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 AMM 飞机维护手册 仪表 CHAPTER 31 - INSTRUMENTS 1(117)
