(2)
The test .uid must be oil at 250'F. instead of the .uid speci.ed in Sec. 25.965(c).
Amdt. 25-36, E.. 10/31/74
FAR 25.1017 : Oil lines and .ttings.
(a)
Each oil line must meet the requirements of Sec. 25.993 and each oil line and .tting in any designated .re zone must meet the requirements of Sec. 25.1183.
(b)
Breather lines must be arranged so that–
(1)
Condensed water vapor that might freeze and obstruct the line cannot accu-mulate at anypoint;
(2)
The breather discharge does not constitute a .re hazard if foaming occurs or causes emitted oilto strikethepilot’s windshield; and
(3)
The breather does not discharge into the engine air induction system.
FAR 25.1019 : Oil strainer or .lter.
(a) Each turbine engine installation must incorporate an oil strainer or .lter through which all of the engine oil .ows and which meets the following requirements :
(1)
Each oil strainer or .lter that has a bypass, must be constructed and installed so that oil will .ow at the normal rate through the rest of the system with the strainer or .lter completely blocked.
(2)
[The oil strainer or .lter must have the capacity (with respect to operating limitations established for the engine) to ensure that engine oil system func-tioning is not impaired when the oil is contaminated to adegree(with respect toparticle size anddensity) thatisgreaterthan that establishedfor the engine under Part 33 of this chapter.
(3)
The oil strainer or .lter, unless it is installed at an oil tank outlet, must in-corporate an indicator that will indicate contamination before it reaches the capacity establishedin accordance with subparagraph(2) of thisparagraph.]
(4)
The bypass of a strainer or .lter must be constructed and installed so that the release of collected contaminants is minimized by appropriate location of the bypasstoensurethatcollected contaminantsarenotinthebypass .owpath.
′
Elodie Roux. Septembre 2003
Subpart E : Powerplant
(5) Anoil straineror .lterthathasnobypass,except onethatisinstalled at anoil tank outlet, must have a means to connect it to the warning system required in Sec. 25.1305(c)(7).
(b) Each oil strainer or .lter in a powerplant installation using reciprocating engines must be constructed and installed so that oil will .ow at the normal rate through the rest of the system with the strainer or .lter element completely blocked.
Amdt. 25-57, E.. 3/26/84
FAR25.1021 :Oil[systemdrains.]
[Adrain(ordrains)mustbeprovided to allow safedrainage ofthe oil system.Each drain must–
(a)
Be accessible; and
(b)
Have manual or automatic means for positive locking in the closed position.] Amdt. 25-57, E.. 3/26/84
FAR 25.1023 : Oil radiators.
(a)
Each oil radiator must be able to withstand, without failure, any vibration, inertia, and oil pressure load to which it would be subjected in operation.
(b)
Eachoil radiatorairduct mustbelocated sothat,incaseof.re, .amescomingfrom normal openings of the engine nacelle cannot impinge directly upon the radiator.
FAR 25.1025 : Oil valves.
(a)
Each oil shuto. must meet the requirements of Sec. 25.1189.
(b)
The closing of oil shuto. means may not prevent propeller feathering.
(c)
Each oil valvemusthavepositivestopsorsuitableindexprovisionsinthe ”on” and ”o.” positionsand mustbe supported sothatnoloadsresultingfromitsoperation or from accelerated .ight conditions are transmitted to the lines attached to the valve.
FAR 25.1027 : Propeller feathering system.
(a)
If the propeller feathering system depends on engine oil, there must be means to trap an amount of oil in the tank if the supply becomes depleted due to failure of anypart of thelubricating system otherthanthetankitself.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：FAA规章 美国联邦航空规章 Federal Aviation Regulations 4(2)
