23-32-00
ú ú 01 Page 10 ú Jan 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL
P. GUN 102-999; The ZONE A switch controls the video source selection for the forward video monitors. The switch also controls the video audio source selection for the forward zone (Ref 23-34-00) and the PA amplifier (Ref 23-31-00). The ZONE B switch controls the video source selection for the aft video monitors and the audio source selection for the aft zone.
Q. GUN 102-999; The PA switch on the SCU sends the video audio through the PA system. This audio has a PTT-3 priority through the PA amplifier. The PA VOLUME switch controls the volume of the video audio. Turn the switch clockwise to increase the volume and OFF to stop the video audio. The CH 1 and 2 switch controls the channel of video audio (channel 1 or channel 2) that is used.
R. GUN 102-999; The PAUSE function on the VTR will be set if the video system is in operation and the passenger address for the airplane is set by the pilots or the flight attendants.
S. Control
(1) Turn-On Procedure
(a)
Provide electrical power (Ref 24-22-00).
(b)
Set PES switch on forward attendant panel P21 to ON.
(c)
GUN 008-101; Perform the following at the video control center: 1) At the control distribution unit:
a) Press SYS POWER switch to on (switchlight on). b) Press MONITOR SEL switch until indicators read VTR 1 PRI. c) Press MON PWR ON switch. Check that light in switch
comes on. d) Press SOURCE SEL switch until indicators read VTR 1. e) If video audio is desired over the PA speakers,
rotate the PA volume control clockwise from OFF to mid-point. Press the SEL switch to select primary or secondary audio, as desired.
2) At the video tape reproducer: a) Insert video cassette into VTR and wait five seconds for tape to thread. b) Press the PLAY switch. 3) Observe video picture on CDU preview monitor and adjust VTR TRACKING control as necessary.
(d) GUN 102-999; Perform the following at the video control center: 1) At the system control unit:
a) Push the SCU SYST PWR switch to the on position (the light comes on the SCU).
2) At the video tape reproducer (VTR-1): a) Put the video cassette tape in the VTR. b) Push the REW switch to make sure the tape is at the
start.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH VIDEO ENTERTAINMENT ú